Manual Steinel NightMatic 2000 (page 3 of 40) (All languages)

592546

Zoom out

Zoom in

1/40

4 5

Installation Instructions

This photo-cell controller

measures ambient bright-

ness and automatically

switches the light ON at

dusk and OFF again at

dawn. Whether you want

light to come ON at the

front door, on the patio or

under the carport, this

photo-cell controller is

installed and ready for

operation in next to no

time wherever you wish

to use it.

The built-in photosensor

registers the ambient

light level and switches

the connected light ON

in the even-ing and

ON again in the morning

all automatically.

Wall mounting

Caution: Installation

means making connec-

tions to the mains power

supply. 230 V means dan-

ger to life! Therefore,

switch off the power first

and use a voltage tester

to make sure the wiring is

off circuit.

Installation of the photo-

cell controller involves

work on the mains power

supply; this means it must

be done properly in ac-

cord-ance with VDE 100.

Please note that the

photo-cell controller must

be protected by a 10 A

circuit breaker. The mains

connection lead must be

no greater than 10 mm in

diameter.

It important to make sure

that the NightMatic 2000 is

not affected by the light

from the luminaire con-

nected (e.g. from direct ex-

posure to light).

Using a screwdriver, undo

the four housing screws by

turning them anti-clock-

wise and remove the hous-

ing cover.

Hold the electronic sys-

tem's housing against the

wall and mark where to

drill the holes, paying

attention to any wiring

already existing in the wall,

drill holes; insert wall

plugs. When installing,

make sure the wires are

fed in from below wherever

possible. Before screwing

on the housing, pierce

through the condensation

water holes at the bottom.

Connection

The unit has the following

marked terminals:

N = Neutral-conductor

terminals

(2 x ) (usually blue)

L = Phase terminal

(usually black, brown

or grey)

L' = Connection to the

switched phase.

If you are in any doubt,

identify the conductors

using a voltage tester.

Principle

Installation

2 lux 10 lux

L (phase)

N (neutral)

Light

Betriebsstörungen

Störung Ursache Abhilfe

NightMatic 2000

ohne Spannung

■ Sicherung defekt, nicht

eingeschaltet Leitung

unterbrochen

■ Kurzschluß

■ neue Sicherung Netz-

schalter einschalten.

Leitung überprüfen mit

Spannungsprüfer

■ Anschlüsse überprüfen

NightMatic 2000

schaltet nicht ein

■ Glühlampe defekt

■ Netzschalter AUS

■ Sicherung defekt

■ Glühlampe austauschen

■ einschalten

■ neue Sicherung,

evtl. Anschluß prüfen

NightMatic 2000

schaltet immer EIN/AUS

■ Der Dämmerungsschalter

wird durch das Licht des

Verbrauchers beeinflußt

■ Dämmerungsschwelle

mittels Stellschraube

erhöhen

Funktionsgarantie

Dieses Steinel-Produkt ist

mit größter Sorgfalt her-

gestellt, funktions- und

sicherheitsgeprüft nach

geltenden Vorschriften und

anschließend einer Stich-

probenkontrolle unterzo-

gen. Steinel übernimmt die

Garantie für einwandfreie

Beschaffenheit und Funk-

tion. Die Garantiefrist

beträgt 36 Monate und

beginnt mit dem Tag des

Verkaufs an den Verbrau-

cher. Wir beseitigen Män-

gel, die auf Material- oder

Fabrikationsfehlern beru-

hen, die Garantieleistung

erfolgt durch Instandset-

zung oder Austausch

mangelhafter Teile nach

unserer Wahl. Eine Garan-

tieleistung entfällt für

Schäden an Verschleißtei-

len sowie für Schäden und

Mängel, die durch unsach-

gemäße Behandlung oder

Wartung oder durch Ver-

wendung von Fremdteilen

auftreten. Weitergehende

Folgeschäden an fremden

Gegenständen sind ausge-

schlossen.

Die Garantie wird nur ge-

währt, wenn das unzer-

legte Gerät mit kurzer

Fehlerbeschreibung, Kas-

senbon oder Rechnung

(Kaufdatum und Händler-

stempel), gut verpackt,

an die zutreffende Service-

station eingesandt wird.

Reparaturservice:

Nach Ablauf der Garantie-

zeit oder Mängeln ohne

Garantieanspruch fragen

Sie Ihre nächste Service-

station nach der Möglich-

keit einer Instandsetzung.

Konformitätserklärung

Dieses Produkt erfüllt die

- Niederspannungrichtlinie 2006/95/EG

- EMV-Richtlinie 2004/108/EG

- WEEE-Richtlinie 2012/19/EG



Is there any way of adjusting the Steinel NightMatic 2000 to turn off after a fixed period of time, please? Submitted on 3-8-2021 at 08:34
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Steinel NightMatic 2000 in the language / languages: All languages as an attachment in your email.

The manual is 0,73 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Steinel NightMatic 2000 Manual

Product: