60283
3
Zoom out
Zoom in
Previous page
1/24
Next page
US
3
•Trinitron
â
and FD Trinitron
â
are registered trademarks of Sony
Corporation.
Macintosh is a trademark licensed to Apple Computer, Inc., registered in
the U.S.A. and other countries.
Windows
â
and MS-DOS are registered trademarks of Microsoft
Corporation in the United States and other countries.
IBM PC/AT and VGA are registered trademarks of IBM Corporation of
the U.S.A.
VESA and DDC
ä
are trademarks of the Video Electronics Standard
Association.
ENERGY STAR is a U.S. registered mark.
All other product names mentioned herein may be the trademarks or
registered trademarks of their respective companies.
Furthermore, “
ä” andâ” are not mentioned in each case in this manual.
Precautions
Warning on power connections
Use the supplied power cord.
Before disconnecting the power cord, wait at least 30 seconds
after turning off the power to allow the static electricity on the
screen’s surface to discharge.
After the power is turned on, the screen is demagnetized
(degaussed) for about 5 seconds. This generates a strong
magnetic field around the screen which may affect data stored on
magnetic tapes and disks placed near the monitor. Be sure to keep
magnetic recording equipment, tapes, and disks away from the
monitor.
Installation
Do not install the monitor in the following places:
on surfaces (rugs, blankets, etc.) or near materials (curtains,
draperies, etc.) that may block the ventilation holes
near heat sources such as radiators or air ducts, or in a place
subject to direct sunlight
in a place subject to severe temperature changes
in a place subject to mechanical vibration or shock
on an unstable surface
near equipment which generates magnetism, such as a
transformer or high voltage power lines
near or on an electrically charged metal surface
in a dusty or smoky environment
inside an enclosed rack
Protection
Do not put foreign objects into the monitor.
Disconnect the monitor if environment exceeds 60°C/140°F.
Ensure AC power cord is not trapped under furniture, TV, etc.
Do not overload wall outlets, extension cords, or convenience
receptacles beyond their capacity.
Never spill liquid of any kind on the monitor.
Notes on cleaning the screen’s surface
The screen’s surface is covered with a thin anti-reflective coating
to enhance the ergonomic characteristics of the monitor. To
ensure that the coating is not damaged, use a soft cloth to clean
the screen’s surface. If necessary, use a soft cloth lightly
moistened with a mild detergent solution, such as hand soap, to
wipe the screen.
Do not use any type of abrasive pad, alkaline cleanser, scouring
powder, or solvents such as alcohol or benzene as they might
damage the anti-reflective coating.
If you use a glass cleaning liquid, do not use any type of cleaner
containing an anti-static solution or similar additive as this may
scratch the screen’s coating.
Do not rub, touch, or tap the surface of the screen with sharp or
abrasive items such as a ballpoint pen or screwdriver. This type
of contact may result in a scratched picture tube.
Notes on cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth lightly
moistened with a mild detergent solution.
Do not use any type of abrasive pad, scouring powder or solvent,
such as alcohol or benzene.
Transportation
When you transport this monitor for repair or shipment, use the
original carton and packing materials.
Display Stand
Do not remove this monitor’s stand.
Use of the tilt-swivel
This monitor can be adjusted within the angle shown below. To turn
the monitor vertically, hold it at the bottom with both hands. Be
careful not to pinch your fingers at the back of the monitor when
you tilt the monitor up verticaly.
Table of Contents
Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Adjustments. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Technical Features . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Appendix
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i
Preset mode timing table . . . . . . . . . . . . . . . . . . . . . . . i
The equipment should be installed near an easily accessible
outlet.
90°
90°
15°
Centering line
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony HMD-A240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony HMD-A240 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info