572498
9
Zoom out
Zoom in
Previous page
1/9
Next page
C O N T E N T S
9
TROUBLE SHOOTING
7
Sometimes, an operational fault can be mistaken for a malfunction or failure. Check the following points and see if
you can find the symptoms of the trouble below before you get in touch with the serviceman. If you cannot locate the
symptoms, contact your nearest dealer.
Symptom
Platter does not
rotate.
No Sound
Musical tempois
off.
Excessive noise.
Sound is distorted.
Tonearm does not
descend.
Intermittent sound.
Possible Trouble
Power cord is unplugged.
Phono cables are not connected properly.
Headshell is not properly attached.
Cartridge lead wires are loose.
Amplifier is not being operated properly.
(function switch, tape monitor switch, speak
switches, etc. are not set correctly).
Platter speed is not set properly.
SPEED ADJUSTMENT knob is not set
properly in accordance with the platter speed.
Ground lead is not connected.
Tracking for is not correct.
Dust or dirt has collected on the stylus tip.
Dust or dirt has collected on the record.
Dust or dirt has collected on the stylus tip.
Tracking force is not correct.
Stylus is worn.
Amplifier’s tone controls are set too high.
Cueing Laver is set to UP position.
Tracking force is not correct.
Stylus is worn.
Record is scratched or warped.
Remedy
Plug cord securely into wall outlet.
Connect cables securely to the PHONO input
jacks on the amplifier.
Fimly secure tonearm locking collar
(see page 4).
Attach lead wires inside headshell properly.
Read the operating instructions that come with
amplifier.
Refer to “Operation” and their uses on page 5.
Refer to “Operation” on page 5.
Connect properly to the amplifier’s ground
terminal.
Refer to tracking force adjustment on page 4.
Clean the stylus tip with a soft brush.
Clean the record with a good quality cleaner.
Clean the stylus tip with a soft brush.
Refer to tracking force adjustment on page 4.
Replace with new stylus.
Set tone conrols to lower position.
Set to DOWN position.
Refer to tracking force adjustment on
page 4.
Replace with new stylus.
Replace record.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sherwood PM-9901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sherwood PM-9901 in the language / languages: English as an attachment in your email.

The manual is 0,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info