572498
6
Zoom out
Zoom in
Previous page
1/9
Next page
C O N T E N T S
64
A S S E M B L Y
1. Remove the main unit with the packing from the
box and take off the packing.
2. Set the 45-rpm adaptor on the main unit.
3. Insert the turntable platter onto the center spindle.
4. Set the slip mat on the platter.
5. Installation of cartridge:
When installing a cartridge, refer to the operating
instructions of that cartridge.
During installation, attach the stylus protector to
guard the stylus tip from damage.
(1) Connect the lead wires to the cartridge
terminals. The terminals of most cartridges are
color coded.
Connect each lead wire to the terminal of the
same color.
White (L+)
.............……………....
Left channel+
Blue (L-)
....……………...............
Left channel-
Red (R+)
..…………...................
Right channel+
Green (R-)
.......…………….........
Right channel-
(2) Install the cartridge to the headshell and tighten
it with screws provided with the cartridge.
6. Insert the headshell into the front end of the
tonearm, then turn the lock nut clockwise with the
headshell firmly held horizontally.
7. Slide counterweight onto tonearm.
Twist it lightly and it will screw onto the rear shaft
of the tonearm.
8. Adjustment of horizontal zero (0) balance and
stylus pressure:
(a) Remove the stylus protector, do not touch the
stylus tip during the adjustment.
(b) Set the cueing lever to the lower position.
(c) Release the arm clamp and lift the tonearm from
the arm rest to free it.
(d) Rotate the counterweight until the tonearm is
approximately balanced horizontally (floats freely).
(e) Refasten the tonearm with the arm clamp.
(f) Hold the counterweight stationary with one hand
and rotate only the stylus-pressure ring to bring
the number "0" of the ring into alignment with the
center line on the tonearm rear shaft.
(g) Rotate the counterweight clockwise until the scale
shows the value corresponding to the pressure of
the used stylus. The stylus pressure of the installed
pick-up system is 2 g. If you use a separate pick-up
system, please follow the manufacturer’s
i n s t r u c t i o n s .
9. Set the anti-skating control knob to the same value
as the stylus pressure.
10. Install the dust cover to the main unit.
󰦙
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sherwood PM-9901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sherwood PM-9901 in the language / languages: English as an attachment in your email.

The manual is 0,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info