757419

Seiko 8B63 Manual

25
Zoom out
Zoom in
Previous page
1/27
Next page
English
English
48 49
Condition Solutions
Reception
of a radio
signal
When the watch is unable
to receive a radio signal
The reception results have
failed and the second hand
points to N (the watch
does not receive a radio
signal).
Do not move the watch while it is receiving a radio signal.
Because it takes time to receive a radio signal successfully, leave the
watch untouched for 12 minutes at the longest.
Place the watch where it is able to easily receive a radio signal.
Transmitting stations may have stopped transmitting radio signals for
some reason (Transmission stop).
Check the website of each transmitting station for further information
concerning a transmission stop. Attempt to receive a radio signal again
after a while.
Reselect the time zone able to receive the radio signal.
Charging
the solar
battery
The stopped watch was
exposed to an adequate
light for longer than “the
time required to fully charge
the watch,” however,
it does not resume its
normal one-second interval
movements.
The time required for charging the watch depends entirely on the amount
of exposed light the watch receives.
Refer to “GUIDELINE OF CHAGING TIME/ACCURACY” to charge the
watch.
The built-in IC of the watch has fallen into an unstable condition.
Refer to “IN CASE OF AN ABNORMAL MOVEMENT” to reset the built-in IC.
Misalignment
of the time
and hand
positions
The watch displays an
incorrect time hour unit,
even though it displays the
precise time of minutes
and seconds.
Make sure that the watch is set to the time zone that covers the place
where you use the watch.
Condition Solutions
Misalignment
of the time
and hand
positions
The watch temporarily
gains or loses time.
1. Place the watch where it is able to receive a radio signal more easily.
2. Conduct manual reception if necessary.
1. In case the watch has been left in a place with an extremely high or
low temperature for a long time, When the watch returns to a normal
temperature, it will display the precise time as before.
2.
If the watch still gains or loses the time, conduct manual reception if necessary.
3. If the watch cannot resume normal movement even after conducting
the above mentioned procedures, consult the retailer from whom the
watch was purchased.
The reception results
are successful, but
the precise time is not
displayed.
1. No crown or button operation is needed, since the automatic hand
position adjustment function will be activated to align the hand
positions. Automatic Hand Position Alignment Function activates once
a minute for the second hand and at 12:00 both for the AM and PM for
the minute and hour hands.
It can be manually adjusted, when you hurry up.
2. If the watch still gains or loses time, refer to “IN CASE OF AN
ABNORMAL MOVEMENT” to perform procedures.
3.
If the watch cannot resume normal movement even after conducting the above
mentioned procedures, consult the retailer from whom the watch was purchased.
The second hand position
is not correctly aligned
in “the reception results
display” or “the reception
level display.”
… 25


Need help? Post your question in this forum.

Forumrules
1

Forum

seiko-8b63

Reset search

  • My seiko will not adjust for daylight savings time. Model 8B63 Submitted on 11-3-2024 at 20:27

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Seiko 8B63 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Seiko 8B63 in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info