700354
3
Zoom out
Zoom in
Previous page
1/4
Next page
OPERATION GUIDE
POWER RATING
The RENEGADE RXS subwoofer enclosure are designed
for high bass levels. Anyhow it is possible, that unsatisfying
sound characteristics could be caused by too low or too
high amplier power. In certain cricumstances this even can
cause a damage to the loudspeakers.
It is recommended to choose rather a more powerful
amplier (ca. 15-20% more Watts RMS than the max. RMS
power rating of the woofer) and to use the amplier not
at the maximum output level (low distortion factor, good
sound characteristics). A weaker amplier at the maximum
level causes worse sound characteristics due to the higher
distortion factor.
Never crank up the output volume of your amplier to the
maximum level or run the amplier into the clipping range.
If the sound ist distorted and not clean, turn back the level
until the distortions disappear.
Please observe the following recommended power ratings:
RXS1000
One amplier with an output power of approx. 160 up
to 250 Watts RMS into 4 Ohms.
Please note that a lower impedance operation causes a
higher output power of your amplier. This increasing could
cause that the amplier run into the clipping range. This
events when more loudspeakers are connected in a parallel-
operation-circuit to the amplier.
Please observe also the minimum impedance of the installed
amplier. In case of doubt ask your specialist dealer.
IMPORTANT NOTE: The subwoofer enclosures have
no integrated limiter or clipper, which is limiting the level
upwards. Overamplied bass peaks leads inevitably to a
burn out of the voice coil of the woofer. A burn out of the
voice coil, caused by clipping/overamping is not covered by
the usual warranty.
IMPORTANT NOTES
Choose a suitable location for your soundsystem, that
neither the driver`s eld of vision or the security of the
inmates will be affected. This stands also for airbag-zones
and safety belts. The permanent temperature of the location
should not be lower than 5°C ant not higher than 50°C.
Protect the device from moisture an humidity.
Ensure that your subwoofer enclosure will not get loose
during the drive an hurt someone in the passenger cabin. It
is recommended, that you mount the subwoofer enclosure
with suitable belts or any other mounting solutions in the
trunk area.
Please observe not to damage any serial components of
your vehicle (airbags, wires, gas tank, etc.) during the
installation of your sound system by drilling or any other
operations.
Never screw or mount any other devices (amps, caps etc.)
onto the subwoofer enclosure, this may cause damage to
the electricity.
For your personal concerns you should choose a
appropriate sound level for the subwoofer enclosure, that
neither the roadworthy of the driver or his concentration will
be disturbed, that he is able to notice possible trafc noises
and acoustical warning signals.
Modern car audio sound systems provide very high acoustic
pressure beyond the 100dB mark. Please observe in this
case, that permanent use of high sound levels may cause
damage to your ability of hearing.
Please ensure by any means the correct polarity of all
connections. Faulty installed and connected devices may
get damage the vehicle and the device permanently.
Please check in any case the operation guide or wiring
manual of your amplier which you’d like to use for the
sound system.
Never connect the speaker terminals with the 12 Volt power
supply, otherwise the speakers may get damaged.
INTERCONNECTION
ENG
RXS 1000
200 WATTS RMS · 400 WATTS MAX.
IMPEDANCE 4 OHMS
Loudspeaker Outputs
Amplier 4 Ohms
Before you start with the installation of the sound system, disconnect necessarily the GROUND connection wire
from the battery to avoid any risk of electric shocks and short circuits.
NOTE
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renegade RXS1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renegade RXS1000 in the language / languages: English, German as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info