698698
3
Zoom out
Zoom in
Previous page
1/19
Next page
4
EN
5
1
7
2
6
3 4
5
A8
Down Up PhonesOn | Menu
CONTROLS FITTED ON THE FRONT OF THE UNIT
1 Down switch: Press the button to navigate down through the menu.
2 Multi-function knob (On, Volume, Source, Balance, Bass, Treble):
Pressing the knob turns the set on. Press the knob again to turn the set off (standby).
In standby mode, all settings are retained.
Depending on the menu chosen, you can turn the knob to change settings or the volume.
The volume is set in 1 dB increments.
3 Up: Press the button to navigate up through the menu.
4 Phones output: Stereo 6.3 mm jack
5 Infrared receiver: This sensor receives the infrared signals from your remote control.
Always point the remote control at this location and make sure that the sensor is not covered.
6 Display: This shows status information and messages that make using the amplifier easier.
7 Power indicator: This display glows blue when the set is in standby mode to show that the set can be
turned on at any time with the remote control or the knob (2).
For operating display:
Flashing of this indicator shows that the protective circuits of the device have disconnected the loudspeak-
er due to a fault or overloading. The device can now only be put back into operation by using the power
switch on its rear side.
Do not place the equipment in the vicinity of a heat source such as an electric fire, radiator, oven or
similar.
The slits and openings in the enclosure provide the ventilation and ensure reliable operation. They must
never be misaligned or covered.
Burning-out of specific components cannot be completely excluded, despite the use of protective de-
vices, if the equipment is severely overloaded by continually using very loud sound levels. A fire might
also be caused inside the equipment in theory, as a result of this type of overloading. Therefore the
amplifier should always be used within its limits and it should not be left unattended.
Only our technical service should undertake the maintenance of your equipment. Maintenance will be
necessary if any type of damage occurs, i.e. if the power cables or plugs are damaged, if an object falls
on the equipment, if the equipment is dropped or if liquid seeps into it. Never open the equipment as
you might touch the mains voltage (230V / 115V), which is dangerous.
Only use furniture and other units for attaching and putting the equipment on that can be obtained
from or are recommended by the manufacturer. You must ensure that moveable tabletop units or
shelves on which the equipment will be placed are always moved very carefully in order to prevent
damage or injuries from being caused if the equipment tips over.
Continuously loud volume can damage your hearing!
Only use a dry, soft cloth to clean your equipment.
Keep the packing for possible transportation use later on and keep the plastic bag well away from chil-
dren, due to the risk of asphyxiation.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadral AURUM A8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadral AURUM A8 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info