600480
1
Zoom out
Zoom in
Previous page
1/4
Next page
VAP Duo WL Silver
MODEL: 90501
INTRODUCTION
The Light incorporates a PIR (Passive Infra Red) sensing device which
continuously scans a preset operating zone and immediately switches
the light on when it detects movement in that area. This means that
whenever movement is detected within the range of the sensor the
light will switch on automatically to illuminate pathways, steps,
patios, porches, or whatever area you have selected to light for rea-
sons of safety, convenience or security.
While there is movement within range of the unit the light will
remain on.
WHILE TO FIT YOUR LIGHT
To achieve best results, we suggest you account the following points:
Ideally the Light should be mounted 1.8 to 2.5 meters (6 to 8ft)
above the area to be scanned (refer Figure).
To avoid damage to unit-do not aim the sensor towards the sun.
To avoid nuisance triggering, the sensor should be directed away
from heat sources such as barbecues, Air-conditioners, other
outside lighting, moving cars and flue vents.
To avoid nuisance triggering, keeping away from the area of strong
electromagnetic disturbance.
Do not aim towards reflective surfaces such as smooth white
walls, swimming pools, etc. The Security light scanning specificati-
ons (Max. 8 meters at 130°) may vary slightly depending on the
mounting height and location. The detection range of the unit
may also alter with temperature change. Before selecting a place
to install your light you should note that movement across the
scan area is more effective than movement directly toward or
away from the sensor. (refer Figure). If movement is made walking
directly towards or away from the sensor and not across, the
apparent detection range will be substantially reduced. (refer
Figure )
FITTING THE UNIT
Installation by a licensed electrician and according to IEC wiring Regu-
lation.
Before commencing any electrical work, ensure mains supply cables
are isolated by switching off and removing the relevant fuse.
1. Unscrew the Terminal Box Cover Screw then remove the Terminal
Box Cover
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Qazqa 90501 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Qazqa 90501 in the language / languages: English as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info