527004
7
Zoom out
Zoom in
Previous page
1/9
Next page
A b o u t
A b o u tA b o u t
A b o u t
t h e
t h et h e
t h e
c h a r g e r
c h a r g e rc h a r g e r
c h a r g e r
The IC-Twin is a fully automatic batterycharger and it charges and maintains your
battery. Because of this, the IC-Twin is very suitable for motorbikes during winter
storage, which are fitted with an alarm installation, or which have difficulty starting
when the level of the voltage is too low.
The IC-Twin can be left connected to the mains power supply keeping the battery in a
good condition. The charger measures and checks the voltage level continuously.
This level will be adjusted automatically whenever necessary. This built-in system
prevents the battery becoming overcharged or entering a gaseous state and the
battery will stay in a perfect condition.
The IC-Twin is a 2-channel battery charger, which can charge up and maintain two
batteries simultaneously. The charger can deliver a charging current of max. 2
Ampère via the first channel (permanent cable output). Via the second channel
(connected by means of the optional cable set) the charger can deliver max. 1
Ampère. If both channels are connected to a battery, each channel can deliver a
maximum charging current of 1 Ampère.
Tip
TipTip
Tip
To fully charge a completely flat battery quickly you must connect the battery to the
first channel only. In this way the flat battery gets the maximum charging current of
2 Amps and the battery will be fully charged in a short time.
After this, you can use both channels again.
P r o t e c t i o n s
P r o t e c t i o n sP r o t e c t i o n s
P r o t e c t i o n s
The IC-Twin is protected to ensure you that the charging process progresses safely.
Temperature
The IC-Twin is protected against excess temperatures. At an internal temperature of
more then 70C the charger will shut down totally.
If the charger is in the thermal stop mode, only the yellow LED is on. In this mode, the
green, ‘power on’ LED is off.
When the charger has cooled down it will continue the charging process.
How the temperature protective devices operate will depend strongly on the ambient
temperature.
U b e r
U b e rU b e r
U b e r
d a s
d a sd a s
d a s
L a d e g e r ä t
L a d e g e r ä tL a d e g e r ä t
L a d e g e r ä t
Das IC-Twin is ein automatischer 12Volt Batterieladegerät. Dieser Lader versorgt und
unterhalt während des Anschließens automatisch Ihren Batterie.
Dadurch ist das IC-Twin ausgezeichnet für Motorräder geeignet, die im Winter mit
einer Alarmvorrichtung versehen sind oder durch ein zu niedriges Spannungsniveau
schlecht starten.
Das IC-Twin kann im Dauerbetrieb an die 230VAC-Stromquelle und die Batterie
angeschlossen werden, da dies der Batterie langfristig zuträglich ist. Das Ladegerät
mißt und überprüft ständig die Batteriespannung, wobei ein konstanter Wert
aufrechterhalten wird. Damit schützt man die Batterie vor einer Überladung
beziehungsweise unerwünschter Gasentwicklung.
Das IC-Twin ist ein 2-kanal Batterieladegerät und kann zwei Batterien gleichzeitig
laden und instandhalten. Über den ersten Kanal (fester Kabelausgang) kann das
Ladegerät einen Ladestrom von max. 2 Ampere liefern. Über den zweiten Kanal
(Anschluss über den zusätzlich erhältlichen Kabelsatz) kann das Ladegerät max. 1
Ampere liefern. Sind beide Kanäle an eine Batterie angeschlossen, werden beide
Kanäle einen maximalen Ladestrom von 1 Ampère liefern können.
Tip
TipTip
Tip
Um eine völlig leere Batterie schnell aufzuladen, verwenden Sie nur den ersten
Kanal und schließen die Batterie daran an. So erhält die leere Batterie den
maximalen Ladestrom von 2 Ampere und ist in kurzer Zeit wieder vollständig
geladen. Anschließend können Sie wieder beide Kanäle verwenden.
S c h u t z v o r r i c h t u n g e n
S c h u t z v o r r i c h t u n g e nS c h u t z v o r r i c h t u n g e n
S c h u t z v o r r i c h t u n g e n
Der IC-Twin ist mit diversen Schutzvorrichtungen versehen, um zu gewährleisten, d
beim Aufladen keine Gefahrensituationen entstehen.
Temperatur
Der IC-Twin besitzt eine thermische Sicherung zum Schutz vor einem übermäßigen
Anstieg der Innentemperatur. Bei einer Innentemperatur von über 70°C schaltet sich
das Ladegerät ganz aus.
Befindet sich das Ladegerät in einem thermischen Stopp, so wird nur die gelbe
Anzeigediode brennen. Die grüne Diode ‘ Power on’ ist dann also erlöscht.
Sobald nun eine hinreichende Abkühlung erzielt ist, kann die Aufladung automatisch
fortgesetzt werden. Der Ansprechpunkt der genannten Schutzvorrichtungen richtet
sich stark nach der Umgebungstemperatur.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proosten IC-TWIN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proosten IC-TWIN in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info