558753

Prem-i-air EH1452 Manual

10
Zoom out
Zoom in
Previous page
1/12
Next page
With a full load of wood, the stove will need to be refuelled approximately every 1.5
hours. Wood can be stacked higher in the stove than solid mineral fuel but care must be
taken that logs do not touch the baffle.
Wood burns most efficiently with the primary air controls closed and the secondary
control partially open. Moving the secondary control will control the burn rate of the
stove.
Note – primary and secondary air is needed to light the stove, see section entitled
‘Lighting the Stove’.
Burn only dry, well-seasoned wood, which should have been cut, split and stacked for at
least 12 months, with free air movement around the sides of the stack to enable it to dry
out. Burning wet or unseasoned wood will create tar deposits in the stove and chimney
and will not produce a satisfactory heat output. Do not use liquid fuels in this appliance.
Size of Fuel
Maximum Log Size
IONA Insert Stove 4KW 200CM
Notes on burning Solid Fuel
Before refuelling, it is important to de-ash the grate. When burning solid fuel, the ash pan should
be emptied at least twice a day or when the level of ash reaches the top of the ash pan. On no
account should the ash be allowed to build up to touch the grate as this will greatly shorten its
life.
When lighting the fire, set the secondary air setting to one quarter open position. Set the primary
air setting to the fully open position. Light in the normal manner with paper and kindling, or use a
fire lighter.
When the fire is well alight regulate the burning rate by adjusting the setting on the primary air
inlet control. The air wash can be opened sufficiently to keep the door glass clean
Approved smokeless coal is recommended for use in this appliance. At first you may find it
helpful to try several fuels to find the most suitable. If you are unable to obtain the fuel you want
ask your supplier, or an approved fuel distributor to suggest an alternative.
Take care to only burn good quality fuels in order to obtain the greatest efficiency and to maintain
the life of the appliance.
Lighting the Stove
We recommend that you have two or three small fires before you operate your stove to its
maximum heat output. This is to allow the paint to cure in steadily and to give a long
service life of the paint finish. During this curing in process you may notice an unpleasant
smell. It is non-toxic, but for your comfort we would suggest that during this period you
leave all doors and windows open.
First, load the fire with starting fuel, i.e. paper, dry sticks and/or firelighters in the mode
chosen, either wood or solid mineral fuel.
Light the fire at the base leaving all air controls open. Allow the fuel to reach a steady
glow and build the fire up gradually. Once you have a good fire established across the
grate bed, further fuel can be added as required.
Shutting Down
In order to shut down the stove, close the primary air controls, then close the secondary
air slider by moving the handle all the way to the left. If the controls are left in this
position, the fire will be starved of air and will go out. If you want to revive the fire it is
recommended that the primary air controls are open first, then open the secondary air
slider.
… 10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Prem-i-air EH1452 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Prem-i-air EH1452 in the language / languages: English as an attachment in your email.

The manual is 5,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info