POWXG4037 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
▪ The blower can be plugged into any 230 volt AC outlet with 10 amps of fuse protection.
The electrical outlet is to be protected by an earth leakage circuit breaker (ELCB) with a
max triggering current of 30 m amps.
8 BEFORE USE
Steps prior to operation
Only operate the device after completely assembling it. Prior to each use, check the power
cord for signs of damage. Under no circumstances should the power cord be used if it shows
any signs of damage.
9 ASSEMBLY
Your new blower vac requires very little assembly work before it is ready for use (Fig. 1).
ATTENTION! The 2 supplied tube parts have to be mounted otherwise the machine will NOT
work! (Build in safety switch!)
9.1 Safety switch
Your blow-vac has a build in safety switch that prevents the machine from being started in
case the supplied tubes are not mounted.
9.2 Shoulder strap
The shoulder strap will be supplied inside the leaf bag. Take the shoulder strap out of the leaf
bag, open the snap fastener, thread the strap through the metal clip on the top of the motor
casing and then close the snap fastener. To adjust the shoulder strap to the required length,
simply slide the adjustable strap buckle forward or backwards.
9.3 Leaf bag (Fig. 2)
To secure the leaf bag to the machine, simply attach the buckle to the top tube section
and pull the expanding bag opening over the leaf discharge point on the bottom of the motor
casing. Then tighten the securing belt.
9.4 Height adjustment (Fig. 3)
Press the height adjusting button (A) and slide the Vacuum/Blower tube (B) to desired length.
It can be extended up to 300 mm.
9.5 Front handle adjustment (Fig. 4)
Adjust the front handle to a comfortable angle. Release the adjusting buttons and the handle
will automatically.
9.6 Rake adjustment (Fig. 5)
Rotate the rake knob 90° anticlockwise and then the rake will automatically pop-up. Lock the
knob by rotating 90° degrees clockwise. The integrated rake will help to loosen debris
between gravel.
10 OPERATION
Ensure that the blower vac is only connected to conventional sockets with a 230-240V
alternating current supply. Only use extension cables if they are really necessary. The use of
extension cables may cause a drop in voltage, which will result in the machine not performing
to its peak or the motor overheating.
10.1 Switching ON/OFF
To switch on the blow/vac push in the on/off trigger switch (9). And hold to switch off the
machine, release the on/off trigger switch.
10.2 Speed regulation
You can vary the speed by turning the switch (10) from 1 (low speed) to 6 (high speed).
