POWX1270 EN
Copyright © 2018 VARO P a g e | 6 www.varo.com
▪ Tighten the nut (20),
The spark guard protects your eyes and hands from sparks flying from the
workpiece. Therefore, always use the spark guard.
7.5 Mounting and adjusting the workpiece support for the grinding wheel (fig. F)
The workpiece support must be adjusted regularly in order to compensate the wear of the
grinding wheel.
▪ Hold the workpiece support (21) against the side of the wheel guard (9) and fit it using the
bolts (22).
▪ Tighten the fasteners handtight.
▪ Adjust the distance between the workpiece support (21) and the grinding wheel (3) to the
smallest possible value, with a maximum of 2 mm.
▪ Tighten the fasteners,
7.6 Mounting and adjusting the workpiece support for the sanding belt (fig. F)
The workpiece support can be mounted at two different positions to the respective mounting
eyes (23).
▪ Hold the workpiece support (24) against one of the mounting eyes {23) and fit it using the
bolt (25) and the screw (26).
▪ Tighten the fasteners handtight.
▪ Adjust the distance between the workpiece support (24) and the sanding belt (6) to the
smallest possible value, with a maximum of 2 mm.
▪ Tighten the fasteners.
8 OPERATION
▪ Before switching on the machine, check if all screws and nuts are tight and if the sanding
belt can rotate freely,
▪ Always grind on the front part of the grinding wheel or sanding belt. Never overcharge the
machine, causing the grinding wheel or sanding belt to come to a halt.
▪ Use the grinding wheel for grinding metal tools. Regularly cool the tools to be cut with
water.
▪ Use the sanding belt for sanding wooden tools.
▪ The machine is not intended for permanent use. Make sure that the machine is not
overheated. After using the machine for 30 minutes, let it cool down to ambient
temperature.
8.1 Switching on and off (fig. A)
▪ To switch the machine on, set the on/off switch (1) to’I’.
▪ To switch the machine off, set the on/off switch (1) to '0'.
9 CLEANING AND MAINTENANCE
The machine does not require any special maintenance.
▪ Regularly clean the ventilation slots.
▪ Regularly remove grindings from the housing and the covers.
