Manual Polti Vaporetto Lecoaspira 910 (page 13 of 16) (English)

481643

Zoom out

Zoom in

1/16

ENGLISH

Unhook the ring locking the tube elbow in place (32) by pulling it outwards (Figure 11).

Pull the tube elbow (33) out of the filter body with the micro-holed net (31) until it comes

right out. Take all the components to pieces and rinse them in running water (Figure 12).

(If the filtering sponge is torn replace it. Purchase a new one from an authorised Polti

assistance centre or call toll-free number).

Unhook the lever for opening the air-output screen (17) and

rotate it upwards (Figure 15). Turn the closure (34) towards

the outside in order to release the HEPA filter.

Pull the HEPA filter out of its seating and replace it with an

original Polti filter.

Note: The filter lasts for about 100 hours (approximately 6

months) when used normally in a domestic

environment. If the force of suction drops

considerably replace the filter cartridge even before

using it for 100 hours.

Unhook the lever for opening the air output filter screen (17) and turn it upwards. After

removing the HEPA filter take out the filter sponge and clean it. Do this periodically, washing

it in running water. If it has deteriorated replace it with a Polti original spare part.

Fig. 15

The suction fan will not start

The suction fan switches off

during suction and the four

indicator lamps start flashing.

The boiler filling pump can be

heard working continuously

The suction power drops.

The appliance does not respond

to commands.

Water is spilled while sucking

up liquids.

No power supply

The level of the liquid inside the

tank is too high.

The output power selected is

too high for the type of surface.

Air in the boiler circuit.

The upholstery nozzle, the

flexible suction tube or the stiff

suction tube are clogged.

HEPA filter exhausted.

The HEPA filter may be wet

The circuit board has received

electronic signals from an

unrelated appliance

Float device clogged.

Check the cable, plug and socket.

Press the switch (1), disconnect the

power cable from the mains plug

and lower the level of the water in

the tank to the level indicated.

Press the switch (1), disconnect

the power cable from the mains

plug and leave the appliance

disconnected for at least 30" in

order to enable the safety

device to reset.

Switch off the appliance, allow it

to cool and repeat the

operations described in the

"Operation" chapter.

Clean the filter and remove any

obstruction from the tubes and

accessories

Replace the filter.

Remove the HEPA filter and

leave it to dry

Disconnect the appliance from

the mains for few minutes and

then try again

Clean the "EcoActive Filter"

water-based filter assembly.

Problem Cause What to do

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Polti Vaporetto Lecoaspira 910 in the language / languages: English as an attachment in your email.

The manual is 1,08 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti Vaporetto Lecoaspira 910

Polti Vaporetto Lecoaspira 910 User Manual - Dutch - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Polti Vaporetto Lecoaspira 910 Manual

Product: