Manual Polti Vaporetto Lecoaspira 910 (page 12 of 16) (English)

481643

Zoom out

Zoom in

1/16

ENGLISH

- Connect the iron (B2) to the one-piece plug proceeding as shown in the "Operation"

section.

- For steam-ironing, adjust the temperature of the iron by positioning the temperature-

control knob (Y) to COTTON-LINEN.

- Wait for 3 or 4 minutes until the push-button lamp (X) extinguishes to show that the sole-

plate of the iron has reached the required temperature.

- Press the steam-supply push-button (X) to enable the steam to come out. The steam flow

will stop when the push-button is released. When you first start to use the iron a few drops

of water may come out of the sole-plate mixed with the steam due to imperfect heat

stabilisation. It is therefore advisable to direct the first jet of steam onto a rag.

- In order to obtain a continuous jet of steam move the sliding switch (W1). The steam

will continue to come out even when the sliding switch is released. To stop the flow of

steam push the sliding switch backwards (W1).

Important Note

Never leave the iron unattended while it is on.

Only iron on surfaces that withstand heat and that allow the steam to permeate through

them.

Before carrying out any type of maintenance make sure that the power cable has been

disconnected from the mains plug.

After using the brushes it is advisable to allow the bristles to cool in their natural position

so as to avoid them getting deformed in any way.

Check the conditions of the gaskets located inside the one-piece plug (B2) periodically.

If necessary replace them with the appropriate spares. Also carry out the same check on

the gaskets for connecting the extension tubes (D) and the handle (A2).

To clean the outside of the appliance just use a damp cloth. Do not use solvents or

detergents as these might damage the plastic surface.

We strongly recommend cleaning the "Eco-Active Filter" water-based filter each time you use

it. Pull the lid of the accessory holder upwards as shown in Figure 2 so that it can be

unhooked. Lift up the water container (25) and remove it from its compartment by the handle

of the container (26) pushing the flap of the built-in socket (24) to one side as shown in Figure

3. Press the lever for opening the handle of the water container (27) and pull (Figure 4 ).

Remove the "EcoActiveFilter" water-based filter assembly (28).

Empty the sucked in material out of the water container (25).

Unhook the ring locking the tube elbow in place (32) by pulling it outwards (Figure 11).

Pull the tube elbow (33) from the body of the filter with the micro-holed net (31) until it

comes out. Take all the components to pieces and rinse them in running water (Figure 12).

Put the water-based filter assembly back together again repeating the operations described

above but in reverse order.

Put the filter assembly correctly back into place inside the tank.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Polti Vaporetto Lecoaspira 910 in the language / languages: English as an attachment in your email.

The manual is 1,08 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti Vaporetto Lecoaspira 910

Polti Vaporetto Lecoaspira 910 User Manual - Dutch - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Polti Vaporetto Lecoaspira 910 Manual

Product: