491862
4
Zoom out
Zoom in
Previous page
1/144
Next page
Connecting the system
02
Section
4
Engb
Precautions before
connecting the system
CAUTION
If you decide to perform the installation
yourself, and have special training and
experience in the mobile electronics
installations, please carefully follow all
of the steps in the installation manual.
Secure all wiring with cable clamps or
electrical tape. Do not allow any bare
wiring to remain exposed.
Do not directly connect the yellow lead
of this product to the vehicle battery. If
the lead is directly connected to the
battery, engine vibration may eventu-
ally cause the insulation to fail at the
point where the wire passes from the
passenger compartment into the
engine compartment. If the yellow
lead’s insulation tears as a result of
contact with metal parts, short-
circuiting can occur, resulting in con-
siderable danger.
It is extremely dangerous to allow
cables to become wound around the
steering column or gearstick. Be sure
to install this product, its cables, and
wiring away in such so that they will
not obstruct or hinder driving.
Make sure that the cables and wires
will not interfere with or become
caught in any of the vehicle’s moving
parts, especially the steering wheel,
gearstick, handbrake, sliding seat
tracks, doors, or any of the vehicle’s
controls.
Do not route wires where they will be
exposed to high temperatures. If the
insulation heats up, wires may become
damaged, resulting in a short circuit or
malfunction and permanent damage to
the product.
Do not cut the GPS aerial cable to
shorten it or use an extension to make
it longer. Altering the aerial cable could
result in a short circuit or malfunction.
Do not shorten any leads. If you do, the
protection circuit (fuse holder, fuse
resistor or lter, etc.) may fail to work
properly.
Never feed power to other electronic
products by cutting the insulation of
the power supply lead of this product
and tapping into the lead. The current
capacity of the lead will be exceeded,
causing overheating.
Before installing this product
Use this unit with a 12-volt battery and neg-
ative earthing only. Failure to do so may
result in a fire or malfunction.
To avoid shorts in the electrical system, be
sure to disconnect the () battery cable
before installation.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer SPH-DA100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer SPH-DA100 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 14,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer SPH-DA100

Pioneer SPH-DA100 User Manual - English - 54 pages

Pioneer SPH-DA100 User Manual - German - 54 pages

Pioneer SPH-DA100 User Manual - Dutch - 54 pages

Pioneer SPH-DA100 User Manual - French - 54 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info