432111
21
Zoom out
Zoom in
Previous page
1/23
Next page
Frequently Asked Questions
19
6 Frequently asked questions
In this chapter you will find the most frequently asked questions and
answers about your Wireless Router.
Set-up
I cannot connect using the Web browser
Check that you have a valid network connection to your Wireless
Router
Check all parameter settings with your Internet provider
Check Internet Explorer* configuration:
- Go to Start and select the Control Panel.
- In the Control Panel select Internet Options
- Ensure that Always dial my default connection is not ticked
*depends on your Web browser
I forgot (or lost) the password. How do I reset my Wireless
Router (Factory Defaults) ?
Make sure the Wireless Router is ON
Use a pen to push the recessed reset button on the rear panel,
holding it down for at least five seconds
Release the reset button and the Wireless Router restarts
Warning
When you reset the Wireless Router using the reset button, all
configuration settings will be lost, also your ISP setting (Internet Service
Provider).
A Wireless PC cannot associate with my Wireless Router
Make sure that the WiFi function of your Wireless Router is enabled
Make sure the Wireless PC has the same SSID setting as your
Wireless Router. See webpage “Channel and SSID”.
You need to have the same security settings on the Wireless PC and
your Wireless Router. See “Security”.
Product behaviour
The signal does not switch on.
Make sure that the electrical power supply is plugged into a wall
outlet
Make sure that the coaxial jack of the electrical power supply adapter
is plugged into your Wireless Router
Make sure you are using the correct power supply for your Wireless
Router
However, if your Wireless Router power if OFF after running for a
while, check for power loss or overcharge. (If your wall outlet has a
switch is it in position ON ?)
If you still cannot isolate the problem, then the external power supply
may be defective. In this case, contact Technical Support for
assistance
The signal is OFF.
Make sure that your Modem Ethernet cable (RJ45) is plugged into the
WLAN port of your Wireless Router and to your modem.
The signal is always OFF.
Confirm with your Internet Service Provider that your Internet
service is active
Confirm your Internet setting with your Internet Service Provider
The signals do not switch ON. Cannot ping the
Wireless Router from the attached LAN.
If you are using the Ethernet connection, verify that your TCP/IP is
properly installed and configured on your PC.
Make sure the Ethernet cable (RJ45) is firmly connected to your
Wireless Router.
Make sure you are using the correct cable type for your Ethernet
equipment
Verify that the IP address is properly configured. For most
applications, you should use the Wireless Router DHCP function to
dynamically assign IP address to hosts on the attached LAN.
However, if you manually configure IP address on the LAN, verify that
the same network address and subnet mask are used for both the
Wireless Router and any attached LAN devices.
The Wireless network is often interrupted.
Move your Wireless PC closer to the Wireless Router to find a
better signal. If the signal is still weak, you can change the angle of the
antenna. There may be interference, possibly caused by microwave
ovens, a Wireless TV link or wireless phones. Adapt the location of
the interference sources or of the Wireless Router.
You can change the wireless channels on the Wireless Router. See
webpage “Channel and SSID”.
The Wireless Router is hot.
This is a normal behaviour
Make sure to never cover the cooling slots
!
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips caw7740n draadloze router at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips caw7740n draadloze router in the language / languages: English as an attachment in your email.

The manual is 3,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips caw7740n draadloze router

Philips caw7740n draadloze router User Manual - German - 26 pages

Philips caw7740n draadloze router User Manual - French - 26 pages

Philips caw7740n draadloze router User Manual - Spanish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info