523074
46
Zoom out
Zoom in
Previous page
1/48
Next page
RQT8020
46
Reference
ENGLISH
Troubleshooting guide
Operation Page
Recording and timer recording
1
2
Play
Continued on the next page
Cannot operate the television.
The remote control doesn’t
work.
Change manufacturer code. Some televisions cannot be operated even if you change the
code.
The remote control and main unit are using different codes. Change the code on the remote
control.
Press and hold [ENTER] and the indicated number button at
the same time for more than 2 seconds.
The batteries are depleted. Replace them with new ones.
Coloured glass may obstruct the signal reception/transmission.
Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight
exposure.
The child lock function is activated.
14
14
3
40
The unit is on but cannot be
operated.
Some operations may be prohibited by the disc.
The unit is hot (“U59” appears on the display). Wait for “U59” to disappear.
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
Press [8] on the main unit to switch the unit to standby.
If the unit doesn’t switch to standby, press and hold [8] on the main unit for about 10 seconds.
The unit is forcibly switched to standby.
Alternatively, disconnect the AC mains lead, wait one minute, then reconnect it.
Cannot eject disc.
Timer recording is in recording standby. Press [z TIMER] to cancel the recording standby.
Linked timer recordings with external equipment is in recording
standby. Press [EXT LINK] to cancel the recording standby.
The unit may have a problem. While the unit is off, press and hold [g] and [CH 1] on the main
unit at the same time for about 5 seconds. Remove the disc and consult the dealer.
If the Child Lock function is activated, above operation does not work. Cancel the Child Lock function.
18–20
21
40
Cannot tune channels.
Cannot download channel
presets.
Check the connections.
You must connect to a television equipped with the Q Link function with
a fully wired 21-pin Scart cable to download channel presets.
7, 8
7
Startup is slow.
Make sure that “Quick Start” is set to “On”.
Even if “Quick Start” is set to “On”, startup is slow if the clock is not set, there was a power
failure or the AC plug has just been connected.
A few dozen seconds after turning on the unit, you can play a disc or start recording to discs
other than DVD-RAM.
Startup takes time for a few minutes after 5:15 am due to system maintenance of this unit.
37
For Continental Europe
For Continental Europe
For Continental Europe
Cannot record.
You haven’t inserted a disc or the disc you inserted cannot be recorded on. Insert a disc the
unit can record onto.
The disc is unformatted. Format the disc.
The write-protect tab on the cartridge is set to PROTECT, or the disc is protected with DISC
MANAGEMENT.
Some programmes have limitations on the number of times they can be recorded. (CPRM)
The disc is full or nearly full. Erase un-needed titles or use another disc.
You cannot record on finalized DVD-R, DVD-RW (DVD-Video format), +R or DVD-RW (DVD
Video Recording format) discs.
Due to peculiarities of DVD-R, DVD-RW (DVD-Video format) or +R, you may be unable to
record onto them if you either insert and remove the disc or switch the unit on and off while a
disc is loaded, a total of fifty times.
DVD-R, DVD-RW (DVD-Video format) and +R recorded on this unit may not be recordable on
other Panasonic DVD recorders.
4, 5
33
32
41
23, 29, 32
Timer recording does not work
properly.
S
HOWVIEW programming does
not work properly.
1
G-CODE programming does not
work properly.
2
The timer programme is incorrect or different timer programme times overlap. Correct the
programme.
The unit is not on timer recording standby. (“z” on the unit’s display is not on.)
Press [z TIMER].
Set the clock.
21
18–20
40
Timer recording does not stop
even when [g] is pressed.
While using timer recording, press [z TIMER]. (“z” disappears.)
When using the linked timer recording with external equipment, press
“EXT LINK”. (“Ext Link” disappears.)
18–20
21
The timer programme remains
even after recording finishes.
The timer programme remains if set to daily or weekly. 20
A part or whole of a recorded
title has been lost.
If there is a power failure or the plug is disconnected from the household AC mains socket
while recording or editing, the title may be lost or the disc may become unusable. You will have
to format the disc ( ) or use a new disc. We cannot offer any guarantee regarding
lost programmes or discs.
RAM
-RW(V)
For Continental Europe
RAM -RW(V)
For Continental Europe For Australia, N.Z. and Asia
Play fails to start even when
[q] (PLAY) is pressed.
Play starts but then stops
immediately.
Insert the disc correctly with the label facing up.
You tried to play a blank DVD-RAM, DVD-R, DVD-RW (DVD-Video format), +R or DVD-RW
(DVD Video Recording format) unplayable on this unit.
When recording to DVD-RAM using EP ( 8Hours ) mode, play may not be possible on DVD
players that are compatible with DVD-RAM. In this case use EP ( 6Hours ) mode.
22
4, 5
35
DVD-Video is not played.
Some DVD-Video cannot be played when you change the ratings level. 35
Alternative soundtrack and
subtitles cannot be selected.
The languages are not recorded on the disc.
You may have to use the discs menus to select languages.
22
No subtitles.
Subtitles are not recorded on the disc.
Turn the subtitles on.
26
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic DMRES10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic DMRES10 in the language / languages: English as an attachment in your email.

The manual is 2,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic DMRES10

Panasonic DMRES10 User Manual - English - 48 pages

Panasonic DMRES10 User Manual - German - 140 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info