Page 15 of 18
11. Adjust TV set and receiver
You have two possibilities to interconnect the receiver and the
display (TV set). It is enough to do only ONE of either the coax
connection or SCART connection.
Coax connection
First, you need to connect the coax cable on both sides (TV and
receiver) then you will have to tune in your TV to the proper
channel. To do so the Oyster just needs to be powered up. Refer
to your TV set manual how to operate your TV to tune in
correctly.
SCART connection
This way needs no tuning of the TV set and will typically give a
better picture quality, therefore it is to be preferred. Simply
connect the SCART cable into the receptacle named “TV scart”
on the receiver side and into the matching one on the TV side.
Almost any TV will auto detect the receiver when switched on
and will automatically change over to SCART input. If not, you
need to refer to the TV manual to find how to get the TV into the
CART (AV) mode.
Once the connection of the TV is OK you should see at least
some Onscreen Display menu coming from the Oyster receiver.
Press the red button on the Oyster remote again to retract the
dish. With the dish retracted the Oyster should switch to Standby
immediately.
