612936

Orbis CTME BASICO Manual

2
Zoom out
Zoom in
Previous page
1/4
Next page
CTME BASICO
COIN OR TOKEN OPERATED TIME METER
INSTALLATION
WARNING: The installation and assembly of electrical equipment must be carried out
by an authorised installer.
- Remove the bottom drawer, open the top cover and insert the conductors thought
the drill hole provided for this purpose.
- Connect the conductors to the terminal strip following the scheme: Terminal 1:
appliance earth connection. Terminals 2 and 3: power supply, marked L (live) and
N (neutral). Terminals 4 and 5: timing circuit (potential-free).
The appliance is internally protected from interference by means of a safety circuit.
Nevertheless, some especially strong electromagnetic fields may affect its operation.
Interferences may be avoided if the following installation instructions are followed:
- The appliance should not be installed close to inductive loads.
- It is advisable to provide a separate line for the power supply (if necessary
provided with a network filter).
- Inductive loads must be provided with interference suppressors (varistor, RC
filter).
PROGRAMMING
IMPORTANT: PROGRAMMING MUST BE CARRIED OUT WITH THE APPLIANCE
DISCONNECTED FROM THE MAINS VOLTAGE.
All the programming is carried out by means of the device situated below the display.
To access this it will be necessary to pull out the coin drawer, remove the two screws
that fasten the top cover and remove this.
The programming device consists of 6 mini-switches numbered 1 to 6 from left to
right. Switches 1, 2, 3 and 4 configure a timing value, as shown in the following table,
and switch 5 defines the value as hours or minutes (ON = hours, OFF = minutes).
Switch 6 has no function.
DESCRIPTION
DISPLAY: Indicates the number of coins until the end of timing.
PAUSE: Timing may be temporarily stopped without loss of memory by disconnecting
the CTME power supply. When the CTME is reconnected the countdown will continue
where it left off.
EARLY WARNING: The display will start to flash one minute before the expiry of the
time corresponding to the last coin.
"CTME BÁSICO" PROGRAMMING EXAMPLES
Example A
1 = OFF
2 = ON
3 = OFF
4 = ON
5 = OFF
Example B
1 = OFF
2 = OFF
3 = ON
4 = ON
5 = OFF
Example C
1 = OFF
2 = OFF
3 = OFF
4 = OFF
5 = ON
TECHNICAL FEATURES
- Nominal voltage: See rating plate
- Frequency: 50 Hz
- Breaking power: 10 A – 2A X 250 V~
- Own consumption: 5 VA
- Precision: ±0.2%
- Memory reserve without power: 1 year
- Temperature range. Operating conditions: -10°C to +45°C
- Casing protection: IP 20 to UNE 20-324
- Maximum number of coins or tokens: 9 (Recognises up to 255)
- Timing by coin or token
- Maximum: 150 hours/coin
- Minimum: 1 minute/coin
- Coin types. Only one of the following types: 0,50€, 1€ and 2€
DIMENSIONS
A016.12.49210
ORBIS TECNOLOGÍA ELÉCTRICA, S.A.
Lérida, 61 E–28020 MADRID
Teléfono:+ 34 91 5672277; Fax:+34 91 5714006
E-mail: info@orbis.es
http://www.orbis.es
12
3
4
5
LN
TIMING
ON
12
3456
TIMING (SEE TABLE)
HOURS
POSITION
MINUTES
POSITION
OFF
VALUE
12
3
4
POSITION
1
2
3
4
5
6
7
8
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
ON
OFF
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
VALUE
12
3
4
POSITION
9
10
15
20
30
45
90
150
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
ON
OFF
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
15 MINUTES PER COIN
30 MINUTES PER COIN
ON
1 HOUR PER COIN
ON
91145.2
201
2


Need help? Post your question in this forum.

Forumrules
1

Forum

orbis-ctme-basico

Reset search

  • Our unit is not timing down. It is set for 15 minutes but not turning off Submitted on 12-6-2018 at 00:08

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Orbis CTME BASICO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Orbis CTME BASICO in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info