612936
1
Zoom out
Zoom in
Previous page
1/4
Next page
CTME BASICO
CONTADOR DE TIEMPO POR MONEDA O FICHA
INSTALACIÓN
ATENCIÓN: La instalación y el montaje de los aparatos eléctricos debe ser
realizada por un instalador autorizado.
- Retirar el cajón inferior, abrir la tapa superior e introducir los conductores por
el taladro dispuesto para ello.
- Conectar los conductores a la regleta siguiendo el esquema.
Borne 1: Toma de tierra del aparato.
Borne 2 y 3: Alimentación, marcando como L (fase) y N (neutro).
Bornes 4 y 5: Corresponden al circuito de temporización (libre de potencial).
El aparato está internamente protegido contra las interferencias por un circuito de
seguridad. No obstante, algunos campos electromagnéticos especialmente fuertes
pueden llegar a alterar su funcionamiento.
Las interferencias pueden evitarse si se tienen en cuenta las siguientes reglas de
instalación:
- El aparato no debe instalarse próximo a cargas inductivas.
- Conviene prever una línea separada para la alimentación (si es preciso
provista de un filtro de red).
- Las cargas inductivas deben estar provistas de supresores de interferencias
(varistor, filtro RC).
PROGRAMACIÓN
IMPORTANTE: LA PROGRAMACIÓN DEBE REALIZARSE SIN TENSIÓN DE
RED EN EL APARATO.
Toda la programación se realiza con el dispositivo situado bajo el display, para
acceder a él, habrá que retirar el cajón de monedas, retirar los dos tornillos que
sujetan la tapa superior y sacar esta.
El dispositivo de programación consta de 6 mini-interruptores numerados del 1 al 6
de izquierda a derecha. Los interruptores 1, 2, 3 y 4 configuran un valor de
temporización según la tabla adjunta y el interruptor 5 hace que este valor sea
horas o minutos (ON = horas, OFF = minutos). El número 6 no tiene función.
DESCRIPCIÓN
DISPLAY: Señala el número de monedas hasta el final de la temporización.
PAUSA: Para detener la temporización temporalmente sin perdida de memoria
basta con desconectar la alimentación del CTME. Al conectar de nuevo el CTME
la cuenta atrás proseguirá donde se dejó.
PREAVISO: Un minuto antes de finalizar el tiempo de la última moneda el display
empieza a parpadear.
EJEMPLOS DE PROGRAMACIÓN DEL CTME BASICO
Ejemplo A
1 = OFF
2 = ON
3 = OFF
4 = ON
5 = OFF
Ejemplo B
1 = OFF
2 = OFF
3 = ON
4 = ON
5 = OFF
Ejemplo C
1 = OFF
2 = OFF
3 = OFF
4 = OFF
5 = ON
CARACTERISTICAS TECNICAS
Tensión nominal: Según etiqueta de
características.
Frecuencia: 50 Hz.
Poder de ruptura: 10 a – 2 AX 250V~
Consumo propio: 5 VA
Precisión:
± 0,2%
Reserva de memoria ante corte de red: 1 año
Temperatura de funcionamiento: -10ºC a +45ºC
Protección de la envolvente: IP 20 según UNE 20-324
Número máximo de monedas o fichas: 9 (reconoce hasta 255)
Temporización por moneda o ficha: Máxima = 150 horas / moneda
Mínima = 1 minuto / moneda
Tipos de moneda: Sólo un tipo de entre los
siguientes: 0,50€, 1€ y 2€.
DIMENSIONES:
A016.12.47458
12
3
4
5
LN
TEMPORIZACIÓN
ON
12
3
4
56
TEMPORIZACIÓN
(VER TABLA)
POSICIÓN
HORAS
POSICIÓN
MINUTOS
OFF
VALOR
12
34
POSICIÓN
1
2
3
4
5
6
7
8
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
ON
OFF
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
VALOR
12
34
POSICIÓN
9
10
15
20
30
45
90
150
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
ON
OFF
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
15 MINUTOS POR MONEDA
30 MINUTOS POR MONEDA
ON
1 HORA POR MONEDA
ON
91145.2
201
ORBIS TECNOLOGÍA ELÉCTRICA, S.A.
Lérida, 61 E–28020 MADRID
Teléfono:+ 34 91 5672277; Fax:+34 91 5714006
E-mail: info@ orbis.es
http://www.orbis.es
1


Need help? Post your question in this forum.

Forumrules
1

Forum

orbis-ctme-basico

Reset search

  • Our unit is not timing down. It is set for 15 minutes but not turning off Submitted on 12-6-2018 at 00:08

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Orbis CTME BASICO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Orbis CTME BASICO in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info