1. Camera
The camera uses either the integrated battery or the accompanying AC
adapter. The battery charges when the AC adapter is used. The power
indicator LED flashes while the battery is charging (red if the camera is off
and green if it is turned on). When the camera is fully charged the indicator
switches off or, if the camera is turned on, is a constant green. The camera
or the monitor can also be charged from a PC using the included USB
cable.
1.1 Camera on/off
Press On/Off for 2 seconds and the camera switches on. The Power
indicator LED is lit. Press On/Off for 2 seconds and the camera switches
off. The Power indicator LED goes out.
1.2 Integrated battery
If the power is disconnected, the camera starts using the battery auto -
matically. When the battery is low, the Power indicator LED will change
from green to red.
1.3 Night vision
The camera has 8 infrared LEDs in order to capture clear images at
distances of up to 3m in total darkness. These are activated automatically
when the inbuilt light sensor registers that the light is inadequate.
Note:The image changes to black/white when “night vision” is active.
1.4 Assembly
Screw the accompanying stand to the camera and tighten the nut.
Find somewhere to place the camera and point the lens at the area that is
to be monitored. Make sure that the child cannot reach the camera or the
adapter cable. The camera can be turned in all directions and is locked/
released with the large screw on the back of the stand. If the camera is to
be attached to the wall, check its placement before fixing in position.
Setup
3
GB
