704396
4
Zoom out
Zoom in
Previous page
1/8
Next page
4
A minus sign (-) appears in the left-most digit of the %SpO
2
display when the device senses the finger has been
removed. The last measured SpO
2
and pulse rate values display for 10 seconds while the device automatically turns
off. The device will automatically shut off (to conserve battery life) approximately 10 seconds after the finger is
removed, or after a 2-minute period of inadequate pulse signals.
If the 9550 does not turn on or if it shuts off unexpectedly:
Verify batteries are correctly inserted. Note: If batteries are installed backwards, the unit will not function.
The batteries are depleted. Replace batteries.
If the problem persists, remove the batteries and contact Nonin Technical Service.
The Oxitest
Plus7
by Datrend Systems, Inc. can be used to verify operation of the pulse oximeter.
Using the Lanyard and Carrying Case
WARNING: Certain activities my pose a risk of injury, including strangulation, if lanyard should become
wrapped around your neck.
CAUTION: A flexible circuit connects the two halves. Do not twist or pull the flexible circuit or
overextend the device’s spring. Do not hang the lanyard from the device’s flexible circuit.
A lanyard and carrying case are provided for convenience. The device will function with or without the lanyard.
If lanyard use is desired, thread the lanyard as shown below.
Onyx II 9550 Care, Maintenance, and Cleaning
The advanced digital circuitry within the device requires no calibration or periodic maintenance other than battery
replacement. The device’s expected service life is 5 years. Field repair of the 9550 circuitry is not possible. Do not
attempt to open the case or repair the electronics. Opening the case will damage the device and void the warranty.
Do not open the 9550 more than 90°, and do not twist or pull on the device when cleaning.
Cleaning the Onyx II 9550
CAUTIONS:
!
Clean the device before applying it to a patient.
Do not sterilize, autoclave, or immerse this device in liquid. Do not pour or spray any liquids into the device.
Do not use caustic or abrasive cleaning agents, or any cleaning agent containing ammonium chloride.
1. To clean, wipe the surfaces with a soft cloth dampened with a 10% bleach solution (household bleach [5.25%
sodium hypochlorite]). Do not use undiluted bleach or any cleaning solution other than those recommended here,
as permanent damage could result.
2. Dry with a soft cloth, or allow to air dry. Ensure that all surfaces are completely dry.
!
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nonin Onyx II - 9550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nonin Onyx II - 9550 in the language / languages: English as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info