488210
17
Zoom out
Zoom in
Previous page
1/20
Next page
£ Turn the Right rotary knob to “Care”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care Rinse”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Rinse frother”. Now press the Right rotary knob.
The messages “Hose to spout” and “and into drip tray” will toggle alternately on your display.
£ Connect the hose to the vertically-adjustable spout (Fig 7).
£ Put the free end of the hose into the hole at the back of the drip tray on the right (Fig 10).
£ Place a sufciently large vessel (with a capacity of at least 0.5 litres) under the spout.
£ Now press the Right rotary knob.
“Frother is rinsing” now appears on the display. Your machine will now begin the automatic rinsing
process. The rinsing process takes approx. 20 seconds.
Once the rinsing cycle is complete, the heating cycle will begin and your machine is once again ready
for operation.
5.2 Rinsing the spout
The spout should be rinsed out regularly. Proceed as follows:
£ Turn the Right rotary knob to “Setting”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care Rinse”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Rinse Spout”. Now press the Right rotary knob.
The message “System is rinsing” will appear on your display.
Once the rinsing cycle is complete, the heating cycle will begin and your machine is once again ready
for operation.
5.3 Cleaning the frothing device
WARNING! Once activated, the programme may not be interrupted!
We recommend that the frothing device be cleaned regularly. Cleaning MUST be carried out, however,
when instructions to that effect appear on your display. Proceed as follows:
£ Turn the Right rotary knob to “Setting”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care Clean”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Clean frother”. Now press the Right rotary knob.
The messages “Hose to spout” and “end into cleaner” will toggle alternately on your display.
£ Connect the hose to the vertically-adjustable spout (Fig 7).
£ Dissolve a little of the cleaning uid (available as an accessory, see Point 9) in a container with
water to make a solution of at least 0.3l. The ratio of cleaning uid to water is given in the manu-
facturer’s instructions.
£ Put the end of the hose into the cleaning solution.
£ Place a sufciently large vessel (with a capacity of at least 0.5 litres) under the spout.
£ Now press the Right rotary knob.
Your machine will now begin the cleaning process. The “Cleaning Activated” message appears on your
display.
After a few moments, the messages “Hose to spout” and “and into drip tray” will toggle alternately on
your display.
£ Connect the hose to the vertically-adjustable spout (Fig 7). Put the free end of the hose into the
hole at the back of the drip tray on the right. Now press the Right rotary knob.
The “Cleaning Activated” message appears on your display.
Once the cleaning cycle is over, the “Empty trays” message appears on the display.
£ Empty the drip and used coffee trays (Figs 1/N and 1/O), clean and replace.
The heating cycle will now begin and the machine will again be ready for use.
5.4 Cleaning the system
Note: When the machine needs cleaning, instructions on how to proceed will be shown on the display. In
order not to prejudice any possible warranty claims, please follow these instructions carefully.
WARNING! Look out for the “Please clean” message appearing on the display. You may continue to
obtain drinks from your machine. Once you have started the cleaning programme, however, it must not
be interrupted. The machine will tell you when to put in a cleaning tablet.
£ Turn the Right rotary knob to “Setting”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care Clean”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Clean System”. Now press the Right rotary knob.
The “Empty trays” message will appear on the display.
£ Remove the drip and used coffee trays (Figs 1/N and 1/O) and empty them.
£ If necessary, ll the water container with fresh water, then replace the water container, drip tray
and used coffee tray.
The machine will now rinse twice.
The “Cleaning tablet in” and “Powder Chute” messages will now toggle alternately on the display.
£ Place a sufciently large vessel (with a capacity of at least 0.5 litres) under the spout (Fig 1/E).
£ Open the lid to the coffee powder chute (Fig 1/M).
£ Put the cleaning tablet into the powder chute and close the lid.
The “Start Cleaning” message appears on your display.
£ Now press the Right rotary knob.
Your machine will now begin the cleaning process. The message “System is cleaning” will appear on
your display. The cleaning process is automatic and lasts approx. 10 minutes.
Once the cleaning cycle is over, the “Empty trays” message appears on the display.
£ Empty the drip and coffee dregs trays (Figs 1/N and 1/O), clean and replace.
£ If necessary, ll the water container with fresh water.
The heating cycle will now begin and the machine will again be ready for use.
5.5 Descaling the system
When the machine needs de-scaling, the “Please descale” message will appear in the display.
You can, however, start the descaling programme manually at any time.
WARNING! Please follow the descaling instructions precisely and in the order they are given! You may
continue to obtain drinks from your machine. We recommend, however, that you start the de-scaling
programme as soon as possible. Failure to descale your machine may exempt any claims under war-
ranty.
WARNING! Once activated, the descaling programme must not be interrupted! Only use proprietary
solvents specially recommended for use in coffee machines. Do not attempt to use vinegar or any
vinegar-based descaling agents.
WARNING! The lter must be removed from the water container prior to starting the descaling programme.
£ Turn the Right rotary knob to “Setting”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care”. Now press the Right rotary knob.
£ Turn the Right rotary knob to “Care Descale”. Now press the Right rotary knob.
The “Empty trays” message will appear on the display.
32 33
5. Care and maintenance 5. Care and maintenance
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nivona CafeRomatica 757 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nivona CafeRomatica 757 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nivona CafeRomatica 757

Nivona CafeRomatica 757 User Manual - German - 21 pages

Nivona CafeRomatica 757 User Manual - Dutch - 20 pages

Nivona CafeRomatica 757 User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info