44
The following buttons are used for
programming:
Coffee strength button (fig. 1/F)
1-cup button (fig. 1/G)
2-cup button (fig. 1/H)
Steam warm-up button (fig. 1/O)
4.1 Filter
Inserting filter
You can purchase a special filter
for the water reservoir in specialist
shops. If you use this filter cor-
rectly, you will not need to descale
your coffee machine as often.
After the filter was inserted, please
adjust the water hardness setting
on level 1 (see chapter 4.2).
➔ Empty the water tank (fig. 1/C
and 2).
➔ Set the insertion and replace-
ment date on the date ring (months)
at the top end of the filter cartridge.
➔ Screw the filter into the bracket
provided in the water reservoir us ing
the assembly tool on the end of
the measuring spoon (fig. 6).
➔ Fill up the reservoir with fresh
water and put it back in the
machine.
➔ Hold a container under the
steam / hot water jet (fig. 1/R) and
turn the valve control knob (fig. 1/P
and 5) to the right to open. The
system will now be rinsed through.
If the machine was in ECO-mode
please repeat operation. The system
will be rinsed (ca. 0,3 L).
... 3. Making coffee
4. Programming functions
automatically switch the operation
off. You can prolong the operation
by turning the control knob back
and forth (fig. 1/P and 5).
Caution: It is hard to remove dried
milk left on the jet after frothing.
Please therefore clean the equip-
ment as soon as it has cooled
down!
· To froth milk, the metal pipe of
the steam jet must be in the
lowest position.
· It is difficult to remove dried
milk left on the jet after frothing.
Therefore clean the equipment
as soon as it has cooled down –
ideally repeat the steam drawing
operation with a cup filled with
fresh, cold water.
