737640
9
Zoom out
Zoom in
Previous page
1/12
Next page
9
1. Position your stand in its desired location.
2. Place (12) weight plates in each cradle.
3. Carefully place barbell handle into rack to load.
Be careful to ensure each end is aligned with
weight stack. NOTE: The release button should
be oriented to the user.
4. If necessary, slide one cradle with weight plates
side to side to allow for a proper fit.
5. Tighten (4) M5 x 10 bolts on each cradle.
6. Place EZ curl bar on bottom bracket.
1. Adjust the weight selector dials to your desired
weight. Be sure to lock the setting each time by fully
depressing the weight selector dial until it locks
into its recessed position. Press the release button
located to the side of the barbell, to allow the weight
selector dial to pop up for further weight selection.
2. Slightly raise the barbell after each of your weight
selections to ensure the intended number of weight
plates lifts with the handset. The barbell and selected
plates should lift smoothly with all unselected plates
remaining in the cradle.
3. If unselected plates are lifting with the barbell, loosen
the (4) bolts located on the underside of the cradle at
one end. Repeat steps 1 and 2 above until selection is
operating correctly. Re-tighten screws.
SYSTEM ASSEMBLY
LOAD YOUR SYSTEM TEST WEIGHT PLATE SELECTION MECHANISM
ALWAYS DEPRESS THE WEIGHT SELECTOR
DIAL TO LOCK THE WEIGHT SELECTION
PRIOR TO LIFTING/MOVING.
STEP 4
STEP 5
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MX Select MX80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MX Select MX80 in the language / languages: English as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info