500096
2
Zoom out
Zoom in
Previous page
1/2
Next page
- ON/OFF (1): Press to stop the alarm and it will sound again 24 hours later. “ ”/
“ ” or “ ”/“ ” are still shown on the display.
3. Alarm 2 settings
Same operations as for Alarm 1: SETTING mode switch (19) to ALM.2 for the time
setting and ALM.2 (4) button for alarm mode.
Note:
If the radio is ON at the wake-up time, regardless the alarm source is radio or buzzer,
the alarm will be triggered with buzzer tone and the radio will be mute. If alarm is
stopped, the radio is resumed.
4. Alarm stop
The alarm is programmed to run for 1 hour and 59 minutes.
Once the alarm 1 or alarm 2 is activated, corresponding alarm indicator with brackets
“ ”/” ” or “ ”/” ” flashes on display.
This unit allows to set two different wake-up times.
1. Alarm 1 time set
Slide the SETTING mode switch (19) to ALM.1 position. Press / (10) to set the
wake time, then press DATE/SET (5) to confirm. Set the hours first, then the minutes.
GB - 10
GB - 6 GB - 7
NAP FUNCTION
THE ALARM AND WAKE-UP MODE
GB - 8
GB - 9 GB - 11
When alarm 1 setting is completed, slide the SETTING mode switch (19) to LOCK
position
Note: To check the alarm 1 time, you can press and hold the ALM.1 button (3) for 4
seconds when the SETTING switch (19) is on LOCK position (the alarm 1 time is
displayed for 3 seconds) or switch the SETTING mode switch to ALM.1 position
2. Alarm 1 mode (buzzer or radio selection)
When the SETTING switch is on LOCK position, press ALM.1 button (3) repeatedly to
switch among wake up by buzzer, radio or alarm off.
1
st
press: “ ” alarm by buzzer
2
nd
press:” ” alarm by radio
3
rd
press: alarm off, no icon displayed
- SNOOZE (10): Press to stop the alarm temporarily, the alarm will ring again when the
snooze period is over. “ ”/“ ” or “ ”/“ ” flashes on display.
To adjust the snooze period (up to 30 minutes, the default time is 9 minutes), press and
hold SNOOZE (10) for 5 seconds, the snooze time blinks on the display, press or
(10) to adjust the value, It will return to clock display if no key is pressed within 5
seconds, the snooze time is stored.
Note: Pressing ON/OFF (1) to stop the alarm will not affect the current status of the
radio.
- ALM. 1 or ALM. 2 (3 or 4): press to turn off the alarm permanently, the alarm
indicator “ ”/ “ ” or “ ”/“ ” are not shown on the display.
This function wakes you up after a short period of time. Only buzzer sound can be
selected for NAP.
1. Press and release the NAP (6) button. The “NAP” icon and the current nap time
flashes on display (2). During this period, adjust nap time by pressing or (19).
Note: The nap range is from 10 minutes to 2 hours. (The default time is 20 minutes)
2. Press NAP (6) to confirm nap time. If no button is pressed during 5 seconds, it will
return to clock display with NAP icon.
3. When the Nap alarm is triggered, press NAP (6) or ON/OFF (1) to stop, “NAP” icon
will disappear.
4. To cancel NAP function before NAP alarm is triggered, press and hold NAP button
(6), the “NAP” icon will blink for two seconds then go off. Release the NAP button.
SLEEP FUNCTION
In sleep mode, radio will turn off automatically after a specified time.
1. To set the sleep time, press and hold SLEEP button (7), at the same time press or
(19) to adjust the value. The time decrements or increments will follow by a faster
rate when you press and hold or button. Release SLEEP (7), your setting is
stored in memory. The sleep time range is from 1 to 120 minutes.
2. The radio is turned on after setting Sleep Time. The radio will turn off when the
preset time elapses. The “SLEEP” icon will be off.
3. If you want to turn off the radio before the SLEEP activates, press ON/OFF button.
The sleep function will be cancelled, “SLEEP” icon will be off.
IMPORTANT SAFETY INSTRUCTIONS
ATTENTION: To reduce the risk of electric shock, do not
remove the cover. There are no user serviceable parts inside
the unit. Refer all servicing to qualified personnel.
The lightening flash with arrowhead symbol within the triangle is a warning
sign alerting the user of “dangerous voltage” inside the unit.
The exclamation point within the triangle is a warning sign alerting the user of
important instructions accompanying the product.
WARNING
- Do not throw batteries in fire!
- Do not mix different types of batteries or old batteries with new ones.
- Never recharge the batteries, apply heat to them or take them apart.
- Attention should be drawn to the environmental aspects of battery disposal.
- Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
- The marking information is located at the bottom of apparatus.
- Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation.
- Ensure that the ventilation is not impeded by covering the ventilation openings with
items, such as newspapers, table-clothes, curtains, etc.
- Do not place naked flame sources, such as lighted candles on the apparatus.
- Use the apparatus only in moderate climates.
- Do not be exposed to dripping or splashing. And that no object filled with liquids, such
as vases, shall be placed on the apparatus.
- Do not use your set immediately after transport from a cold place to a warm place,
there may be condensation problems.
- Make sure that you keep your set away from water and high temperatures.
- Clean the player with a soft cloth, or damp chamois leather. Never use solvent.
- Under the influence of electrical fast transient or/and electrostatic phenomenon, the
product may malfunction and require user to power reset.
If at any time in the future you should need to dispose of this product please
note that Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority
or retailer for recycling advice.(Waste Electrical and Electronic Equipment
Directive)
THE TIME PROJECTION
1. Turn on or off the projector with the ON/OFF switch (11) at the back of the projector.
2. Rotate the projected time by 180º with the ROTATE button (12) at the back of the
projector.
3. Swivel the projector to move the projected time.
LISTENING TO THE RADIO
1. Press ON/OFF (1) to turn on the radio, press this button again to turn it off.
2. Switch to FM or MW with the Band selector (17).
3. Select a radio station with tuning knob (18). The frequency is displayed (2) for a few
seconds. Then it returns to clock mode
4. Adjust the volume (16) to the desired level.
5. For a better reception, in FM extend the antenna (20); in MW rotate the unit.
未命名-1 2009-9-8, 16:212
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Muse M-180 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Muse M-180 in the language / languages: English as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Muse M-180

Muse M-180 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info