495073
30
Zoom out
Zoom in
Previous page
1/30
Next page
30
TROUBLESHOOTING
If you have any further questions, please contact your authorised dealer on site
All information, diagrams and specifications in these operating instructions are based on the latest product information at the
time of going to press. We reserve the right to make changes without prior notice.
ENGINE DOES NOT START
CAUSE REMEDIAL ACTION
Ignition switch set to OFF Set switch to ON
Fuel tank empty Fill fuel tank
Primer not depressed adequately
Slowly and fully depress primer 10 x
Engine flooded
Implement the starting process with the choke lever in the
operating position
Waste fuel Fill tank with fresh fuel
Dirty spark plug Replace or clean spark plug
ENGINE DOES NOT RUN CONSTANTLY AT NO LOAD
CAUSE REMEDIAL ACTION
Air filter blocked Clean or replace air filter
Waste fuel Fill tank with fresh fuel
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel
ENGINE DOES NOT ACCELERATE
CAUSE REMEDIAL ACTION
Waste fuel Fill tank with fresh fuel
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel
ENGINE HAS NO POWER OR STOPS DURING CUTTING
CAUSE REMEDIAL ACTION
Cutting head entangled with grass Stop the engine and clean the cutting attachment
Dirty air filter Clean or replace air filter
Waste fuel Fill tank with fresh fuel
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel
CUTTING HEAD DOES RELEASE LINE
CAUSE REMEDIAL ACTION
Cutting head entangled with grass Stop the engine and clean the cutting attachment
No line in the cutting head Wind up new line
Coil jammed Replace coil
Cutting head dirty Clean coil and coil housing
Line fused together Pull apart, take out the fused part and wind up the line
again
Line twisted when wound up Pull apart and wind up the line again
Not enough line released Tap the bump head and pull out the line until 10 cm of line
is outside the cutting attachment
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MTD 990 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MTD 990 series in the language / languages: English as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MTD 990 series

MTD 990 series User Manual - German - 31 pages

MTD 990 series User Manual - Dutch - 31 pages

MTD 990 series User Manual - French - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info