R331 Rechargeable Remote Control
16. Finding More Than One Remote
If you own more than one Motorola TV Easy Find Remote Control and Base Station, you can set
each Base Station to find only its own remote with 16 unique codes. With the first power up of the
Base Station, it will be set to find ALL remotes. To set the Base Station so that it finds a specific
remote when there are multiple remote in the household, follow the instructions on the following
page:
1. Press and hold both clock setting keys (+H and +M) at the same time for 3 seconds.
The display shows the current ID, from 1 to 16, or ALL.
2. Press the +M key to cycle from 1 to 16 including a selection for all remotes in the
household.
3. Then press the +H key to confirm the selection.
To set the remote to the same ID as the Base Station, follow these instructions:
1. Press and hold the TV key on the remote and while holding it pressed, press the OK
key for one second and release both keys at the same time. Next press the MENU key to
enter the ID learn mode (both the STB and AUX lights remain on).
2. Press the Find key on the Base Station – the remote will accept the new ID and the
lights will flash once and then turn off.
3. To exit this mode without changing the code, simply press any key on the remote
control.
17. Troubleshooting Learning
You can only learn one device type under any one mode key. For example, only learn TV codes
under the TV mode, DVD codes under the DVD mode, etc. If you are trying to learn from a
"Universal" remote, it might have more than one code type stored under a mode.
a. No functions may be stored under the LEARN key, or in the STB mode.
b. Depending on the remote you are trying to learn, some keys may not be learnable.
c. Only one original device type can be learned per individual mode.
d. Use fresh batteries for your original remote, and make sure the batteries in your
Motorola TV Easy Find Remote Control are fully charged.
e. Keep at least three feet away from incandescent or low-energy lights when learning.
f. Before learning, clear all learned commands (refer to Section D-II) then try learning 2 or
3 commands initially.
g. Point your original remote at the bottom end of your Motorola Remote Control so the IR
elements on both remotes are directly in line with each other (see diagram on page 13).
You may need to adjust the height of either remote to achieve this.
h. Avoid learning your original remote's Volume/Mute keys unless you are sure these
operate the same device.
i. Avoid learning your original remote's VCR or DVD transport keys unless you’re sure
these operate the same device.
j. If learning the first or second keys for a mode results in continuous errors then try the
following: