494243

Marmitek Invisible Control 4 Manual

5
Zoom out
Zoom in
Previous page
1/29
Next page
5. STANDBY MODE
The Invisible Control can be connected to the mains or can work using just a battery. If
you are inserting a battery, the Invisible Control will automatically switch to stand-by
mode after 4 hours, to conserve energy. You can activate the Invisible Control by press-
ing a button on your remote control within 50 cm of the receiver. A red light will flash
to confirm the receiver is ready for use. After reactivation, the Invisible Control can
receive all signals from the remote control within a distance of 4 to 8 m, under an angle
of 30°. The Invisible Control will switch to stand-by mode when it has not been used for
4 hours.
If you have connected the Invisible Control to the mains, it will remain switched on. You
do not need to activate the Invisible Control with your remote control first.
6. FREQUENTLY ASKED QUESTIONS
• In a few cases, the Receiver may be disrupted by interference and cannot, therefore,
pick up the signals it receives. If this is the case the red light will be continuously illu-
minated than the Receiver must be relocated. This interference is caused by equip-
ment in the vicinity such as dimmers, energy-saving light bulbs, IR alarms and so on.
Direct sunlight can also disrupt the Receiver.
• Invisible Control does not work with remote controls which use High Frequency sig-
nals (such as B&O).
• Please ensure that the LEDs of the IR extender cable are placed correctly to the
infrared sensor of the A/V device, this has to be done very precisely. The exact posi-
tion can be found easily by shining at it with a flashlight.
• Some IR windows from set-top and satellite boxes are very sensitive and are easily
disrupted. These devices then receive too much infrared light and will either work
badly or not work at all. Relocate the IR LED so that less infrared light is received via
the IR window.
Do you have other questions that have not been resolved by the above information?
Please go to www.marmitek.com
5INVISIBLE CONTROL BLACK/WHITE 4
ENGLISH
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marmitek Invisible Control 4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marmitek Invisible Control 4 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info