494219
57
Zoom out
Zoom in
Previous page
1/59
Next page
Trouble-Shooting
If your camera appears to be malfunctioning, check the
list below to see whether or not you have forgotten some-
thing.
1. The shutter release button will not move.
A) Did you unlock the shutter release button? (p.30)
B) Did you wind the film advance crank until it stops?(p.30)
2. The mirror is locked in the up position.
(Cannot see anything through the finder.)
A) Did you release the shutter without a battery in the
camera? Has the battery been correctly inserted into the
camera, or is it backwards? Is the correct battery type in-
serted into the camera?
Press the battery check button, as far as it will go, to lower
mirror. (p.22)
B) Did you lower the mirror lock-up lever? If so, raise it.
p.51)
C) Did you release the shutter with the shutter speed dial
set to the
0
position?
If so, move the shutter speed dial to B or 1/1000 sec, (p.28)
3. The developed roll of film has 1 or 2 frames less
than it should have.
A) Did you align the start marks with the film advance crank
after placing the roll-film insert into the camera?
The film should always be set to the start mark before
placing the film insert into the camera. (p.24)
B) Did you properly align the start marks of the film and
roll-film insert?
Check the instructions once again. (p.24)
4. The PD Prism Finder’s LED’s do not illuminate
when pressing the meter switch.
Did you set the camera’s shutter speed dial to the
0
po-
sition? If not, there will be no electrical connection. (p.35)
5. You may receive an electric shock when an
electronic flash is connected to the X-sync
terminal and you touch the hot-shoe. Also, you
may receive an electric shock when an elec-
tronic flash is attached to the hot-shoe and
you touch the X-sync terminal.
As a precaution against possible shock, always keep the
safety cover on the terminal when not in use (see p.49)
56
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mamiya M645 1000S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mamiya M645 1000S in the language / languages: English as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info