Manual Lowrance EP-10 Fuel Flow (page 5 of 8) (English)

599453

Zoom out

Zoom in

1/8

and properly terminated. Such a bus provides network connection

nodes at various locations around your boat.

This is similar to the telephone wiring in a house. If you pick up a

phone in your living room, you can hear someone talking into the phone

in the bedroom.

Network Nodes

A network bus is built of network nodes spread along a backbone.

Network nodes are made by fitting T-shaped connectors into the

backbone (using the sockets on the sides), and attaching a display unit or

sensor at the bottom of the T.

Using our telephone example, the T connectors are similar to telephone

jacks. The backbone is like the phone wiring running through a house.

Phones in a house must be connected to each other to communicate, and

in the same way only sensors and display units plugged into the NMEA

network can share information.

Connections found in the middle of the bus will have one or more of these

T-shaped connectors with the backbone cables plugged into both sides.

Connections at the end of a network will have the backbone plugged into

one side, and a terminator plugged into the other, as shown in the

following figure.

NMEA 2000 network node located at the end of a NMEA 2000 bus.

Adding a Network Node

You can add a node anywhere along the network backbone where a

connection already exists. This connection could be at the end of the

network (between a T connector and a terminator), between two T

connectors, between a T connector and a backbone extension cable, or

between two extension cables. Wherever you want to add the new node,

simply separate the sockets of the old connection and attach your new T

connector between them.

Backbone cable

(to rest of bus)

LEI or Lowrance

device needs an

open T.

Terminator at

the very end

of the bus

Cable from

sensor or

display unit

T connector

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance EP-10 Fuel Flow in the language / languages: English as an attachment in your email.

The manual is 0,97 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Lowrance EP-10 Fuel Flow Manual

Product: