486847

Lewenstein Multilock 700de Manual

42
Zoom out
Zoom in
Previous page
1/46
Next page
www.lewenstein.nl
38
VERVANGEN
VAN DE MESJES
VERVANGEN VAN HET BOVENMES:
1. Om het mes te verwijderen
draait u de bovenmesschroef los
en haalt u het mes uit de houder.
2. Zet het nieuwe mes in de houder.
3. Draai dan aan het handwiel
totdat het bovenmes in de
laagste stand is. Zorg ervoor dat
het bovenmes voor het ondermes
zit op een afstand tussen de 0.5
en 1 mm.
4. Draai dan de bovenmesschroef
voorzichtig vast.
1. Bovenmesschroef
2. Steekplaat
3. Bovenmes
4. Ondermes
VERVANGEN VAN HET ONDERMES:
1. Om het mes te verwijderen
draait u de ondermesschroef los
en haalt u het mes uit de houder.
2. Zet het nieuwe mes in de houder.
3. Zorg ervoor dat de bovenkant
van het mes op gelijke hoogte
met de steekplaat zit.
4. Draai dan de ondermesschroef
vast.
De afstelling van de messen is
belangrijk om goed te kunnen
snijden.
REPLACING
THE KNIVES
REPLACING THE UPPER KNIFE:
1. To remove the knife, loosen the
upper knife set screw and pull
up the upper knife.
2. Insert the new knife into the
upper knife holder.
3. Then turn the pulley by hand
until the upper knife is in the
down position. Check that
the upper knife is in front of the
lower one and adjust the
clearance between it and the
edge of the lower knife to
between 0.5 mm and 1 mm.
4. Retighten the upper knife
securely.
1. Upper knife set screw
2. Needle plate
3. Upper knife
4. lower knife
REPLACING THE LOWER KNIFE:
1. Loosen the lower knife set screw
and pull down the lower knife.
2. Insert the new knife into
the lower knife holder.
3. Position the lower knife so that
its edge is flush with the needle
plate.
4. Tighten the lower knife set
screw.
It is important to adjust the align-
ment of the upper en lower knives
for sharp cutting.
REMPLACER
LES COUTEAUX
REMPLACER LE
COUTEAU SUPÉRIEUR:
1. Dévisser la vis du maintien du
couteau et le tirer.
2. Insérer le nouveau couteau dans
l’attache.
3. Tourner la poulie à la main
jusqu’à ce que le couteau soit
en position basse. Contrôler
que le couteau supérieur soit
bien devant le couteau inférieur
et ajuster l’espace entre eux ainsi
que la position du couteau
inférieur qui doit être entre
0.5 mm et 1 mm.
4. Revisser la vis.
1. Vis couteau supérieur
2. Plaque aiguille
3. Couteau supérieur
4. Couteau inférieur
REMPLACER LE
COUTEAU INFÉRIEUR:
1. Dévisser la vis du couteau
inférieur et le tirer.
2. Insérer le nouveau couteau.
3. Positionnez le de manière à ce
que son bord soit contre la
plaque aiguille.
4. Resserrez la vis.
Il est important de bien aligner le
couteau supérieur et inférieur.
AUSWECHSELN
DER MESSER
AUSWECHSELN DER OBERMESSER:
1. Lösen Sie die Obermesser-
schraube lockern und entfernen
Sie das Messer.
2. Setzen Sie das neues Messer ein.
3. An das Handrad drehen, bis das
obere Messer in den tiefsten
Position ist. Dabei ist das
Obermesser vor dem
Untermesser.
Die Messer überlappen
ca. 0.5 mm bis 1 mm.
4. Drehen Sie die Obermesser-
schraube vorsichtig fest.
1. Obermesserschraube
2. Stichplatte
3. Obermesser
4. Untermesser
AUSWECHSELN
DER UNTERMESSER:
1. Lösen Sie die Untermesser-
schraube lockern und entfernen
Sie das Messer.
2. Das neues Untermesser in die
Messerhalterrille einpassen, so
dass die geschliffene Kante des
Untermessers mit der Stichplatte
bündig ist.
3. Drehen Sie die Untermesser-
schraube fest.
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lewenstein Multilock 700de at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lewenstein Multilock 700de in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info