626336
112
Zoom out
Zoom in
Previous page
1/191
Next page
Wheel changing
109
Operating the pillar jack (if supplied)
For any wheel:
1. Remove the rubber plug (1) from the
jacking tube corresponding to the wheel to
be changed.
2. Insert the jack pillar into the base (2).
3. Fit the handle (3) to the pillar and adjust
the height so the jacking peg (4) can be
inserted into the jacking tube.
NOTE: The jack handle operates as a ratchet -
one side raises the jack, then turn the handle
over to lower the jack.
WARNING
ENSURE that you are familiar with operating
the jack BEFORE using it to raise a vehicle.
ONLY jack the vehicle using the jack
location points described or personal injury
or damage to the vehicle could occur.
DO NOT use the jack without the base fitted -
the vehicle would not be properly supported
and could cause personal injury.
ENSURE that the peg is FULLY engaged in
the jacking tube.
ENSURE that the pillar is vertical NOT at an
angle.
112

Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Land Rover Defender 110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Land Rover Defender 110 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info