680904
9
Zoom out
Zoom in
Previous page
1/10
Next page
9
4.4 Anschaltung für „EVPL light“-Produkte
Mit der Maßnahme „EVPL light“ werden folgende Produkte realisiert:
Ethernet Connect 2�0
Wholesale Ethernet VPN 2�0 (WEV 2�0)
CFV Ethernet 2�0
Die Anschaltung der Interfaces des NV4660 ist hierfür wie folgt:
Physikalisches Interface Logische Port-
Bezeichnung
Anschaltung
GIG 0/1
Nicht relevant
Der Steckplatz dient zur Anschaltung an das Netz der Deutschen
Telekom und liegt in der Verantwortung der Deutschen Telekom�
Zur Anschaltung (und ggf� auch bei der durch den Kunden beizu-
stellenden Gebäudeverkabelung) wird ein Glasfaserkabel vom Typ
„SingleMode 9 μm/125 μm” benötigt�
Optionaler Steckplatz/
WAN-Port (xDSL)
Nicht relevant
Der Steckplatz dient zur Anschaltung an das Netz der Deutschen
Telekom und liegt in der Verantwortung der Deutschen Telekom�
Zur Anschaltung (und ggf� auch bei der durch den Kunden beizu-
stellenden Gebäudeverkabelung) wird ein Ethernetkabel vom Typ
(mind� Cat-3) benötigt�
GIG 0/2 1
LAN-Anbindung des Kunden (Combo-Port)
Die Anschaltung des lokalen Netz des Kunden an das NV4660
kann wahlweise über Glasfaser (SFP-Anschluss mit 1000BaseSX
oder 1000BaseLX jeweils mit physikalischer Anschaltung LC) oder
Kupfer (10/100/1000Base-T mit Autonegotiation) erfolgen�
Die aktive Buchse wird automatisch erkannt (Default-Verhalten)�
Das Glasfaser Interface ist fest auf 1GE (full duplex) eingestellt�
Das BaseT Interface ist entweder fest auf
10/100 GE (full duplex) oder
Autonegotiation (10/100/1�000 MBit/s) eingestellt�
Falls davon abgewichen werden muss, ist der Remote Service zu
verständigen�
Die notwendige SSt. zur Anschaltung des Kunden-LAN’s ist bei
der Beauftragung unbedingt korrekt vom Kunden mit anzugeben.
GIG 0/3 2
GIG 0/4 3
GIG 0/5 4
T4 (n�a�)
Anhängig von der Beauftragung wird ein T4 Interface ist als RJ-45
Schnittstelle bereitgestellt und gibt auf Pin 4 und 5 den T4-Taktaus-
gang (2048 kHz) aus� Die weiteren Pins werden nicht benutzt�
Tabelle 7: Anschaltung für „EVPL light“-Produkte
4.5 Infos zur Version der Gundkonfiguration
Die Grundkonfiguration ist die einzige Konfiguration, wenn das RD gestartet wird� Es werden darin nur serviceunabhängige
Dinge, wie z� B� die Konfiguration für VLAN 7 (PPP zum BNG) und VLAN 3 (Management und IP-Adress-Vergabe per DHCP),
dauerhaft abgespeichert�
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lancom Netvanta 4660 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lancom Netvanta 4660 in the language / languages: German as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info