508772
4
Zoom out
Zoom in
Previous page
1/151
Next page
4
You will hear a long beep
and the zone indicator stops
flashing. The sensor is now
programmed to the control
centre
Note:
You may program up to 4 sensors to one zone. Zone 4 is an alert zone; sensors in this zone are for
alert purpose ONLY and will not trigger the alarm.
Step 4:
After synchronising the sensor to the control centre, you may test the communication by placing the
magnet beside the transmitter (where the red marking is) and then removing the magnet from the
transmitter.
When the magnetic contact is closed,
the receiver will not beep.
When the magnetic contact is broken
(open), you will hear a beep and a zone
indicator will flash
Beeping will be according to the zone number (type of alert switch is set to alert) 1 beep for zone 1, 2
beeps for zone 2 etc, until the sensor is closed.
Note: If the type of alert switch is set to chime, the control centre will chime once for every signal
activated. If the switch is set to OFF, no audio alert will sound.
Step 5:
The sensor should be mounted on a door or window frame with double sided tape. The magnet should
be mounted on a door or window with double sided tape or screws. Make sure the magnet is aligned
with the red marking on the transmitter. If the König logo is upside down after mounting the sensor,
remove the front cover and rotate it so it is in the upright position.
Magnet
button
Sensor
Separate the magnet
from the sensor
Control centre “long beep”.
Zone indicator OFF
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-ALARM210 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-ALARM210 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 2,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info