166248
6
Zoom out
Zoom in
Previous page
1/8
Next page
6
Troubleshooting
The LED mounted on the end panel of the amplifier lights up in two different colors
depending on the condition of the amplifier. Green indicates that the amplifier is turned on
and no trouble exists. When it turns red this indicates that the protection circuit has been
engaged. The LED on the top of the amplifier chassis indicates that the amplifier is on.
When the protection circuit is engaged, this LED turns off.
Green power indicator off, no output:
With Volt Ohm Meter (VOM) check:
1. +12v power terminal
2. Ground terminal
3. Remote turn-on lead
Green power indicator on, no output:
• Check RCA connections
• Test speaker outputs with known good speaker
• Check function of source unit
• With VOM in AC volts position check RCA for signal
No output from one channel:
• Check RCA and speaker connections for that channel
• Swap RCA connections from left to right
• Swap speaker connections between channels
Red LED protection indicator is lit and there is no output:
Case 1: Amp is very hot
• Thermal protection is engaged. Check for proper impedance at speaker
terminals. Also check location of amplifier to ensure proper air flow
around heatsink.
Case 2: Output resumes momentarily when system is
turned off and back on.
• Short circuit protection is engaged. With VOM check for short between
speaker positive and negative, and between speaker terminals and ground.
Alternator noise (a whining that varies with engine RPM)
• Make sure that the ground for the source is as short as possible and
connected to bare chassis metal. The stock radio ground may not be sufficient.
• Check RCA cable routing and condition. Keep RCA cables away from all
power wires.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kicker ix 404 impulse at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kicker ix 404 impulse in the language / languages: English as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info