Pulse measurement information
The pulse rate measurement starts when the heart symbol in the display flashes
with the same rhythm of your pulse rate.
With ear clip
The pulse sensor works with infra-red light and measures the changes of the light
transmissivity of your skin, which are caused by your pulse beat.
Before tucking the pulse sensor to your ear-lobe, rub it with your fingers
approximately 10 times in order to increase the blood circulation.
Avoid interference pulse.
• Attach the ear clip carefully to your ear-lobe and search the best point
for the measurement (heart symbol flashes without interruption).
• Don’t exercise directly under strong light incidence like e.g. neon light,
halogen lamps, spot light emitter and sunlight.
• Exclude completely vibration and loose contact of the ear clip sensor
inclusive cable. Always attach the cable with the help of the clip to your
clothes.
With hand pulse sensors
An extra-low voltage produced by means of the contraction of the heart is caught
by the hand pulse sensors and evaluated by the electronic system.
• Grab the contact surfaces always with both hands.
•Avoid abrupt grabbing.
• Hold your hands steady and avoid contractions and rubbing on the
contact surfaces.
With chest pulse sensor
Please follow the appropriate instructions.
Only one way of pulse measurement is possible: either with ear clip or withhand
pulse sensors or with chest pulse sensor. If there is no ear clip or plug-in receiver in
the pulse box on the front then wrist pulse measuring is activated. If an ear clip or
plug-in receiver is connected with the pulse box then wrist pulse detection is auto-
matically deactivated. It is not necessary to pull out the wrist pulse sensors.
Battery notes
The following examples indicate that the battery has to be changed:
• bad or no pulse measurement at all
• bad contrast field on display
• malfunction
Malfunction of training computer
Press the reset shortcut or change the batteries.
Brake resistance display
The brake resistance is divided into steps that go from 1-10. If this division
should disappear or get lost, restore them as follows:
• Press the ”Reset” button and let it go again.
• Press the "SET” button and leave it pressed (while all segments are
being shown) until "CAL” appears.
•Turn back handwheel up to minimum adjusting. Press "SET” button
•Turn forward up to maximum adjusting. Press "SET” button.
End of action.
Training and operating instructions
19
GB
Note:
