520018
3
Zoom out
Zoom in
Previous page
1/12
Next page
3
For Your Safety:
The Ergometer should be used only for its intended purpose,
i.e. for physical exercise by adult persons.
Any other use of the equipment is prohibited and may be dan-
gerous. The manufacturer cannot be held liable for damage or
injury caused by improper use of the equipment.
The Ergometer has been designed in accordance with the latest
standards of safety. Any features which may have been a possible
cause of injury have been avoided or made as safe as possible.
The unit requires a power supply of 220-230 V/50 Hz. It should be
connected only to a safety socket with a single 10-A fuse. Before
commissioning the appliance pay attention to the fact that the cor-
rect plug-in power supply unit (observe marking) has been connect-
ed properly. Do not under any circumstances carry out electrical re-
pairs or alterations yourself. Always ensure that such work is done
by a properly qualified electrician.
Important: disconnect the apparatus from the mains before
doing repair, maintenance or cleaning work.
Incorrect repairs and structural modifications (e.g. removal or re-
placement of original parts) may endanger the safety of the user.
In case of enquiry, please contact your Kettler dealer.
Damaged components may endanger your safety or reduce the life-
time of the equipment. For this reason, worn or damaged parts
should be replaced immediately and the equipment taken out of use
until this has been done. Use only original Kettler spare parts.
If the equipment is in regular use, check all its components thor-
oughly every 1–2 months. Pay particular attention to the tightness of
bolts and nuts. This applies especially to the securing bolts for sad-
dle and handlebars. The brake tension should also be checked at
regular intervals and adjusted as necessary. This applies especially
to the securing bolts for saddle and handelbars.
Instruct persons using the equipment (in particular children) on
possible sources of danger during exercising.
Before beginning your program of exercise, consult your doc-
tor to ensure that you are fit enough to use the equipment. Base
your program of exercise on the advice given by your doctor.
Incorrect or excessive exercise may damage your health.
Before beginning your program of training, study the instruc-
tions for training carefully.
Possibly occurring noise during reverse pedalling result from
engineering and are absolutely safe.
Our products are subject to a constant innovative quality assurance.
We reserve the right to perform technical changes resulting therefrom..
Any interference with parts of the product that are not
described within the manual may cause damage, or en-
danger the person using this machine. Extensive repairs
must only be carried out by KETTLER service staff or qua-
lified personnel trained by KETTLER.
Before assembling or using the ergometer, please read the following instructions carefully. They contain important in-
formation for use and maintenance of the equipment as well as for your personal safety. Keep these instructions in a
safe place for maintenance purposes or for ordering spare parts.
Handling the equipment
Before using the equipment for exercise, check carefully to en-
sure that it has been correctly assembled.
It is not recommended to use or store the apparatus in a damp
room as this may cause it to rust.
The Ergometer is designed for use by adults and children
should not be allowed to play with it. Children at play behave
unpredictably and dangerous situations may occur for which
the manufacturer cannot be held liable.
The Ergometer complies fully with DIN EN 957 - 1/5, class A. It
is therefore suitable for therapeutic purposes.
The apparatus requires no special servicing. All bearings have
permanent lubrication or are maintenance-free.
Do not use corrosive or abrasive materials to clean the equipment. En-
sure that such materials are not allowed to pollute the environment.
Ensure that no liquids penetrante the interior of the Ergometer.
The ergometer has a electric brake system operating indepen-
dent of speed which is maintenance - free and does not require
any adjusting work.
The Ergometer works independent of revolutions per minute.
Please keep original packaging of this article, so that it may be used
for transport at a later date, if necessary.
Instructions for Assembly
Ensure that you have received all the parts required and that
they are undamaged. Should you have any cause for com-
plaint, please contact your Kettler dealer.
Before assembling the equipment, study the drawings carefully
and carry out the operations in the order shown by the diagrams.
The correct sequence is given in capital letters, and in some cases
you are referred to a more detailed explanation (see below).
The equipment must be assembled with due care by an adult person.
The fastening material required for each assembly step is shown
in the diagram inset. Use the fastening material exactly as in-
structed. The required tools are supplied with the equipment.
Bolt all the parts together loosly at first. Do not tighten any of the
bolts until the assembly operation has been fully completed.
For technical reasons, we reserve the right to carry out prelim-
inary assembly work (e.g. addition of tubing plugs).
To pull off the pedal arms screw a bolt M 12 (it’s not supplied
by the manufacturer) into the threaded opening after removing
the protective cap and bolt.
List of spare parts page 15
When ordering spare parts, always state the full article number,
spare-part number, the quantity required and the inspection num-
ber stamped on the back.
Example order: Art. no. 7988-500/spare-part no. 10118062/ 2
pieces/inspection no......
Important: spare part prices do not include fastening material; if
fastening material (bolts, nuts, washers etc.) is required, this
should be clearly stated on the order by adding the words “with
fastening material“.
KETTLER (GB) Ltd. · Kettler House, Merse Road · North Moons Moat · Red-
ditch, Worcestershire · B98 9HL · Great Britain
KETTLER International Inc. · 1355, P.B. Box 2747 Virginia Beach · VA
23450 USA
www.kettler.net
Assembly Instructions
GB
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kettler Ergoracer 07988-500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kettler Ergoracer 07988-500 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kettler Ergoracer 07988-500

Kettler Ergoracer 07988-500 User Manual - English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info