701229
6
Zoom out
Zoom in
Previous page
1/8
Next page
C7-100ct: Surface-Mount Installation
1) Remove the vehicle panel and check
to ensure that the mounting screw
will have adequate clearance.
2) Place the surface-mount fixture on the vehicle
panel at the desired mounting location and
mark the locations of the center mounting screw
hole and the approximate center of the left
and right semicircular cutouts (for the wires).
3) Using a 1/16-inch (1.5 mm) drill bit, drill a pilot hole
through the panel at the center screw location.
4) Using a 1/4-inch (6 mm) drill bit, drill a
hole for each of the tweeters wires at
the locations you marked in step 2.
5) Screw the surface-mount fixture to the vehicle
panel using the supplied #8 sheet metal screw
(hand-tighten) and #8 flat metal spring nut.
Feed a tweeter wire through each semicircular
cutout in the mounting fixture and the
1/4-inch holes you drilled in the panel.
6) To attach the tweeter to the fixture, observe the
indented locking slots on the outer edge of the
tweeter body and align these with the tabs visible
on the inside walls of the fixture. Slide the tweeter
into the fixture and secure by pressing down on
the tweeter and giving it a small clockwise turn.
7) Connect the tweeter’s wires to the wire leads from
the amplifier, observing correct polarity. Install
the protection capacitor as noted on page 5.
8) Re-install the vehicle panel, taking care to route the
new wiring so as not to interfere with any vehicle
mechanisms (window mechanisms, for example).
Diagram B:
Surface-Mount Fixture Installation
6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JL Audio C7-100ct at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JL Audio C7-100ct in the language / languages: English as an attachment in your email.

The manual is 2,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info