507366
3
Zoom out
Zoom in
Previous page
1/4
Next page
TROUBLESHOOTING
If there is no sound from any of the speakers:
• Check that receiver/amplifier is on and that a source is playing.
• Review proper operation of your receiver/amplifier.
If there is no sound coming from one speaker:
• Check the “Balance” control on your receiver/amplifier.
• Check all wires and connections between receiver/amplifier and
speakers.
• Make sure no wires are touching other wires or terminals and
creating a short circuit.
• Make sure all wires are connected. Make sure none of the
speaker wires are frayed, cut or punctured.
• In Dolby
®
Digital or DTS
®
modes, make sure that the receiver/
processor is configured so that the speaker in question is
enabled.
• Turn off all electronics and switch the speaker in question with
one of the other speakers that is working correctly. Turn
everything back on, and determine whether the problem has
followed the speaker or has remained in the same channel.
If the problem is in the same channel, the source of the problem is
most likely with your receiver or amplifier, and
you should consult
the owner’s manual for that product for further information.
If the
problem has followed the speaker, consult your dealer for further
assistance or, if that is not possible, visit www.jbl.com for further
information.
If the system plays at low volumes but shuts off as
volume is increased:
• Check all wires and connections between receiver/amplifier and
speakers.
• Make sure all wires are connected. Make sure none of the
speaker wires are frayed, cut or punctured.
• If more than one pair of main speakers is being used, check the
minimum impedance requirements of your receiver/amplifier.
If there is no (or low) bass output:
• Make sure the polarities (+ and –) of the left and right “Speaker
Inputs” are connected properly.
• Consider adding a powered subwoofer to your system for use with
digital “.1” surround formats.
Single-Stereo Amplifier
Dual-Stereo Amplifier
BI-WIRING
The outer connection panel and internal dividing network of the
TL260 is designed so that separate sets of speaker cables can be
attached to the low-frequency transducer and midrange/high-
frequency transducer portions of this dividing network. This is
called bi-wiring. Bi-wiring can provide several sonic advantages
and considerably more flexibility in power amplifier selection.
Figure 4.
Figure 5.
Figure 6.
3
26766_TL260 OM_ENG 18/04/06 12:51 Side 3
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL TL260 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL TL260 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info