554914
1
Zoom out
Zoom in
Previous page
1/2
Next page
UC-280 wireless interface 1 / 2 MFT51208
UC-280 Wireless Interface
The UC-280 is an 8-zone interface linking JA-60 wireless detectors
with hard-wired security control panels. It can also send triggering
signals to a JA-60A wireless outdoor siren and/or UC-216 and UC-222
universal receivers. Additionally, it can receive signals from Jablotron
RC-xx remote controls. If necessary, UC-282 expander modules can
be used to increase the number of zones up to 40.
Specification
Power 12 V DC (10.5 V – 16.0 V)
Power consumption typ. 50 mA (all relays off)
max. 100 mA
Zone outputs Z1-Z8 8x optoMOS relays 100 mA / 60 V
with COM1 common terminal
Outputs 3x optoMOS relays 100 mA / 60 V
Tamper NC with COM2 common terminal
Fault, Battery NO with COM2 common terminal
X, Y and Siren inputs activated
when switched to GND (filter 0.2
sec., 1 V DC triggering level)
Operating frequency 433.9 MHz
Working range with JA-60 100 m (open area)
Working range with RC 30 m (open area)
Working environment indoor use (class II, EN 50131-1)
Operating temperatures -10 °C to +70 °C
Operating humidity max. 90 %
Dimensions 188 x 135 x 40 mm
Weight 800 g
Hereby, Jablotron Ltd., declares that this UC-280 is in compliance with
the essential requirements and other relevant provisions of Directive
1999/5/EC. Original of the conformity assessment can be found at the
web page
www.jablotron.cz, section Technical support.
Note: Although this product does not contain any harmful materials we
suggest you to return the product to the dealer or directly to the
producer after usage.
Purchase package contains: electronic board, metal case, antenna,
screws, dowels, and manual.
Installation
The UC-280 is an electronic module built-in to a metal case
(protected by a tamper switch). The case should be installed on a wall
with its antenna in a vertical position. The device should not be
installed close to any metal structures or other objects obstructing radio
signal transmission.
Route the wires through the hole in the rear part of the housing.
Attach the case to the desired place using the provided screws.
Connect the antenna.
Terminals:
Z1-Z8 Zone 1-8 output relays’ contacts, max. 100 mA / 60 V, pulse
length can be set by 1s/3s jumper, normally closed or
normally opened mode is selected by the NO/NC jumper
COM1 common terminal of Z1-Z8 relays
TMP tamper relay output (tamper signal from wireless detectors,
a wireless siren and the UC-280 tamper switch), max.
100 mA / 60 V
BAT low battery relay output (low battery signal from wireless
detectors 1-8 or a wireless siren), max. 100 mA / 60 V
TRB trouble relay output (trouble signal from wireless detectors
1-8 or a wireless siren - e.g. lost communication), max.
100 mA / 60 V
COM2 common terminal of TMP, BAT and TRB relays
GND power supply ground terminal
SIR triggering input for activation of JA-60A wireless siren (the
siren sounds as long as this input is closed to GND, max.
15 minutes)
X input, which can trigger relay X of a UC-216 or UC-222
universal receiver when switched to GND
Y input, which can trigger relay Y of a UC-216 universal
receiver when switched to GND
OUT input, which can trigger output OUT of a UC-216 universal
receiver when switched to GND
+12V power voltage terminal
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron UC-280 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron UC-280 in the language / languages: English as an attachment in your email.

The manual is 0,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info