555036
2
Zoom out
Zoom in
Previous page
1/2
Next page
CA-1202 user manual – Mode 3 - 2 / 4 – MHF53500
3. Remote blocking of the car
When the GSM pager receives the SMS command IMO it will reply with a
confirmation SMS and block (immobilize) the engine. If the ignition key is on
when the GSM pager receives the command IMO, immobilization will occur as
soon as the ignition key is switched off which will be confirmed by SMS.
Unblocking the car is only possible by the SMS instruction UNIMO.
4. Car location
If your GSM provider offers a location service you can obtain the location of the
car by just sending the instruction LOCATOR. The GSM pager will reply e.g.
+420603012345 county: Jihocesky, District: Jindrichuv Hradec, Name: Nova Ves nad Luznici.
Distance 5.4 km. E14*52'1"@N48*50'24" + -200m 15:23:01 18.09.01
The GSM pager can send the location automatically in the case of an alarm or
immobilization by the IMO command
2
.
5. Phone calls by an installed hands free set
If the HF-03 hands free set is installed, it is
possible to receive and make phone calls via
the GSM pager.
Incoming calls – to answer them, press any
button on the RC-40 remote control. By
pressing any button again, the call will be
terminated.
To make a call – you can call up to 4
preprogrammed numbers while you are
driving. By pressing one of buttons A, B, 1 or 2
on the remote control you will dial the
corresponding number (preprogrammed by the installer)
By pressing any button again, the call will be terminated. When armed, all
incoming calls are automatically rejected. If the car is blocked (by the IMO
instruction) all calls are automatically answered (it is then possible to listen to
and to speak to the car remotely).
6. Car battery low voltage reporting
The GSM pager checks the voltage of the car battery. If the voltage is too low
(10V) it will notify users via an SMS message. The GSM pager can be backed up
by a BB-01 battery. Thus, the GSM pager can send SMS messages (but not work)
even when the car battery is disconnected. The manufacturer recommends regular
BB-01 checking once a year. The battery should be replaced every two years.
2
Must be set by the installer
CA-1202 user manual – Mode 3 - 3 / 4 – MHF53500
7. Remote service
When it is necessary to change the basic settings of the GSM pager like phone
numbers etc you do not need to contact the installer. Instead it is possible to
change settings remotely.
8. Central monitoring station communication
The GSM pager allows central monitoring via GPRS data protocol. Please ask
your supplier for details.
9. Roaming
If you travel abroad and your SIM card supports roaming, the GSM pager will
work there too (the functions LOCATOR and CREDIT might be not available).
10. LED indicator signals
The LED indicator is used to show
the status of the GSM pager.
Warning! If the LED indicator
starts flashing fast after the
ignition is switched off, it will not
be able to send any messages nor
call in the case of an alarm
.
LED state Meaning
permanently ON Connecting to a GSM network
or a phone call
Interrupted light Car was stopped
(immobilization)
Flashing fast GSM network is not available
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron CA-1202 - mode 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron CA-1202 - mode 3 in the language / languages: English as an attachment in your email.

The manual is 0,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Jablotron CA-1202 - mode 3

Jablotron CA-1202 - mode 3 Installation Guide - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info