If the product overheats or produces smoke or an unusual odour, discolours or
becomes deformed in an abnormal way, immediately turn off the scanner, remove the
batteries where applicable, and disconnect the cables. Stop using the scanner and
contact your dealer or IRIS customer support to receive instructions on the procedure
to follow.
Take care not to drop the scanner or expose it to physical impacts.
Do not place or store the scanner outdoors, in a car, near heat sources, in locations
that are dusty, damp or exposed to impact, vibration, condensation, high
temperatures, sunlight, strong light, or rapid changes in temperature or humidity.
Never attempt to disassemble, modify, or repair the scanner or any of its components
yourself.
Special precaution concerning the model equipped with Wifi transmission only (IRIScan
Book Executive 3, IRIScan Anywhere 3 Wifi, IRIScan Pro 3 Wifi):
Radio waves from this product may adversely affect the operation of other devices,
such as medical equipment, measuring instruments in aeroplanes, or automatically
controlled devices, such as pacemakers, automatic doors, or fire alarms, and any other
device that is sensitive to radio waves.
When using this product near such devices or inside a medical facility, follow the
directions marked on the devices concerned and the instructions for authorized staff
members at the facility, and follow all posted warnings and directions on the device to
avoid causing an accident.
USB power supply
The USB cable should be placed to avoid abrasions, cuts, bending, twisting, and kinking
of the connectors.
Do not place objects on top of the USB cable and do not allow the cable to be stepped
on or run over.
Be particularly careful to keep the USB cable straight at the end.
Unplug the scanner and the USB cable, and refer servicing to qualified service
personnel under the following conditions: liquid has entered the scanner; the scanner
has been dropped
or the case has been damaged; the scanner does not operate normally or exhibits a
distinct change in performance.
After fully charging the scanner using the USB cable (the battery indicator is then fully
displayed on the screen), disconnect the cable to use in nomadic mode.
Battery-related safety instructions
For models with interchangeable batteries (IRIScan Book), never leave dead batteries
in the device, because they may corrode and cause irreversible damage to the device
(the warranty does not cover this type of incident). When replacing the batteries,
handle them carefully to avoid all risk of injury or fire due to leakage, overheating,
explosion, erosion, or any other damage to the product.
For models with a built-in rechargeable, non-interchangeable lithium battery (IRIScan
Anywhere 3 or IRIScan Anywhere 3 Wifi), do not open the scanner and never remove
the battery. It should be replaced by certified technical personnel only. In case of doubt
about battery performance, stop using the scanner and contact your dealer or IRIS
customer support to receive instructions on the procedure to follow.
If you are not planning to use the scanner for a long period (more than a month), be
sure to remove the batteries from models that allow it (IRIScan Book).
If you have not used the scanner with non-interchangeable lithium battery (IRIScan
Anywhere 3 or IRIScan Anywhere Wifi) for at least a month, remember to charge it
fully before its first use.
Keep batteries out of the reach of children. If battery acid comes into contact with skin
or eyes, immediately rinse the affected area thoroughly with water and seek medical
treatment. If a battery is swallowed, seek medical treatment immediately.
