Manual Ignis AKH 2001 IX (page 4 of 4) (English)

806331

Zoom out

Zoom in

1/4

the front wall of the oven and resting it on the respective support. To

prevent smoke and to collect cooking juices, it is advisable to place a

drip-tray with half a litre of water on the rst level.

The rod has a plastic

handle which must be removed before starting to cook, and used at the

end of cooking to avoid burns when taking the food out of the oven.

Pizza

Lightly grease the trays to ensure the pizza has a crispy base. Scatter

the mozzarella over the pizza two thirds of the way through cooking.

CLEANING AND MAINTENANCE

Make sure that the oven has cooled down before carrying out any maintenance or cleaning. Do not use steam cleaners. Do not

use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these could damage the surfaces of the appliance. Wear

protective gloves. The oven must be disconnected from the mains before carrying out any kind of maintenance work.

EXTERIOR SURFACES

Clean surfaces with a damp microbre cloth. If they are very dirty,

add a few drops of pH -neutral detergent. Finish o with a dry cloth.

Do not use corrosive or abrasive detergents. If any of these products

inadvertently comes into contact with the surfaces of the appliance,

clean immediately with a damp microbre cloth.

INTERIOR SURFACES

After every use, leave the oven to cool and then clean it, preferably

while it is still warm, to remove any deposits or stains caused by

food residues. To dry any condensation that has formed as a result

of cooking foods with a high water content, leave the oven to cool

completely and then wipe it with a cloth or sponge.Activate the

“Diamond Clean” function for optimum cleaning of internal surfaces

(Available only on certain models).

Clean the glass in the door with a suitable liquid detergent.

ACCESSORIES

Soak the accessories in a washing-up liquid solution after use, handling

them with oven gloves if they are still hot. Food residues can be

removed using a washing-up brush or a sponge.

LOWER THE TOP HEATING ELEMENT (Only in some models)

The top heating element of the grill can be lowered to clean the upper

panel of the oven: Extract the heating element from its seating, then

lower it. To return the heating element to its position, lift it up, pull it

slightly towards you and make sure that the tab support is in its proper

seating.

REMOVING AND REFITTING THE DOOR

To remove the door, open it fully and lower the catches until they are

in the unlock position (1). Close the door as much as you can (2). Take

a rm hold of the door with both hands - do not hold it by the handle.

Simply remove the door (3) by continuing to close it while pulling it

upwards (a) at the same time until it is released from its seating (b).

1 2

~60°

~15°

Put the door to one side, resting it on a soft surface. Ret the door by

moving it towards the oven, aligning the hooks of the hinges with their

seating and securing the upper part onto its seating.Lower the door

and then open it fully. Lower the catches into their original position:

make sure that you lower them down completely. Try closing the door

and check to make sure that it lines up with the control panel. If it does

not, repeat the steps above.

CLICK & CLEAN - CLEANING THE GLASS

After removing the door and resting it on a soft surface with the

handle downwards, simultaneously press the two retaining clips (1) and

remove the upper edge of the door by pulling it towards you (2).

1 2

Lift and rmly hold the inner glass with both hands, remove it and

place it on a soft surface before cleaning it (3).

To correctly reposition the inner glass, make sure that the “R” is visible

in the left-hand corner and the clear surface (not printed) is facing up.

First insert the long side of the glass indicated by “R” into the support

seats, then lower it into position (4). Ret the upper edge (5): a click

will indicate correct positioning. Make sure the seal is secure before

retting the door.

4 5

REPLACING THE LAMP

Disconnect the oven from the power supply, unscrew the cover from

the light, replace the bulb and screw the cover back on the light.

Reconnect the oven to the power supply. Do not use the oven until the

light cover has been retted.

Please note: Only use 25W/230~ V, G9 type, T300°C halogen bulbs. The

bulb used in the product is specifically designed for domestic appliances

and is not suitable for general room lighting within the home. Light bulbs

are available from our After-sales Service.

TROUBLESHOOTING

What to do if... Possible reasons Solutions

The oven is not working. Power cut.

Disconnection from the mains.

Check for the presence of mains electrical power and whether the

oven is connected to the electricity supply.

Turn o the oven and restart it to see if the fault persists.

400011376991

You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:

• Visiting our website docs . whirlpool . eu

• Using QR Code

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When

contacting our After-sales Service, please state the codes provided on your product's identication

plate.

XXXXXXXXXXXXXX

Model: xxxXXXXxx

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ignis AKH 2001 IX in the language / languages: English as an attachment in your email.

The manual is 2.62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ignis AKH 2001 IX

Ignis AKH 2001 IX Quick start guide - German - 4 pages

Ignis AKH 2001 IX User Manual - Dutch - 4 pages

Ignis AKH 2001 IX User Manual - French - 4 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ignis AKH 2001 IX Manual

Product: