26
4
SELCALL/ALE OPERATION
4
ï TEL call
Allows you to make a telephone call through a tele-
phone interconnect service provider.
• Preparation for TEL call
Sending a Selective Beacon call on several TEL call
channels, and check the propagation on each chan-
nel to select the channel of good signal quality. (p. 20)
• Sending TEL call
q Push [
∫∫
] or [
√√
] to select the desired channel for
TEL call.
w Push [CALL] momentarily to enter the Call menu.
e Push [
ΩΩ
CLR] or [OK
≈≈
] to select ‘TELCALL.’
• ‘TELCALL,’ ‘TEL-DISCONNECT,’ ‘SEL BCON,’ ‘SEL-
CALL’ are selectable.
r Push [
√√
] to select ‘ID,’ then select an intended ID.
• Last selected ID is displayed.
• Enter the 4-digits (or 6-digits depending on Initial set
mode setting) number of the intended ID using 10-key-
pad directly. Or push [OK
≈≈
] to enter ID selection, push
[
∫∫
]/[
√√
] to select the pre-programmed ID, then push
[OK
≈≈
] to fix the ID.
t Verify ‘SelfID’ for your own ID.
y Push [
√√
] to select ‘TEL.’
u Push [OK
≈≈
] to enter TEL number selection.
• Push [
∫∫
]/[
√√
] to select the pre-programmed TEL num-
ber, then push [OK
≈≈
] to fix the number.
i Push [
CCAALLLL
] for 1 sec. to transmit TEL call.
• While calling, push [CALL] to cancel the call.
• After TEL call
q After telephone call is finished, push [
CCAALLLL
] mo-
mentarily to enter the Call menu.
w Push [
∫∫
] or [
√√
] to select the call selection, then
push [
ΩΩ
CLR] or [OK
≈≈
] to select ‘TEL-DISCON-
NECT.’
• While connecting the TEL call, ‘TEL-DISCONNECT’ ap-
pears automatically as first selection call.
e Push [
CCAALLLL
] for 1 sec. to transmit the disconnect
call.
• Until ‘TEL-DISCONNECT’ is transmitted, the telephone
interconnect service provider counts the time for charg-
ing.
Convenient: Disconnecting the TEL call
Just push [
CCAALLLL
] for 1 sec. to transmit the disconnect
call, when connecting the TEL call, The transceiver
automatically selects ‘TEL-DISCONNECT‘ from the
call selection while connecting the TEL call.
