477562
52
Zoom out
Zoom in
Previous page
1/100
Next page
52
5
Conduzca su tractor hacia adelante durante aproxima-
damente cinco pies y entonces hacia marcha atrás cinco
pies (150 cm). Repita este proceso tres (3) veces.
Su tractor esta ahora dispuesto para la operación nor mal.
SPURGO DELLA TRASMISSIONE
Per assicurare il buon funzionamento prestazionale del
trattore, si raccomanda di spurgare la trasmissione prima di
mettere in funzione il trattore per la prima volta. Ciò consentirà
di eliminare le bollicine d’aria che possono essersi formate
nella trasmissione durante il trasporto.
IMPORTANTE: SE LA TRASMISSIONE E’ STATA SMON-
TATA PER RIPARAZIONI O PER LA SOSTITUZIONE,
RICORDARSI DI FARE LO SPURGO DOPO LA REIN-
STALLAZIONE PRIMA DI RIMETTERE IN FUNZIONE IL
TRATTORE.
Parcheggiare il trattore su una superficie piana in modo
che non si metta in movimento in alcuna direzione. La
leva del freno di stazionamento deve essere disinnestata
al fine di eseguire l’operazione seguente.
Disinnestare la trasmissione attivando il comando di ruota
libera.
Avviare il motore e mettere la leva dell’acceleratore
sulla posizione di lento (slow). Accertarsi che il freno di
stazionamento non sia tirato.
Premere a fondo il pedale di avanzamento, tenerlo premuto
per cinque (5) secondi, quindi rilasciarlo. Premere a fondo il
pedale di retromarcia, tenere premuto per cinque (5) secon-
di, quindi rilasciarlo. Ripetere la procedura per tre (3) volte.
Spegnere il trattore girando la chiavetta di avviamento
sulla posizione “OFF”.
Innestare la trasmissione mettendo il comando di ruota
libera sulla posizione di marcia.
Avviare il motore e mettere la leva dell’acceleratore sulla
posizione di lento (slow).
Fare andare avanti il trattore di circa 1,50 metro, quindi
farlo indietreggiare, in retromarcia, della stessa distanza.
Ripetere tre volte questa operazione.
Il trattore è pronto per il normale funzionamento.
TRANSMISSIE ONTLUCHTEN
Voor de juiste werking en prestaties wordt aangeraden om de
transmissie te ontluchten voordat de trekker voor het eerst
wordt gebruikt. Hierdoor wordt lucht binnenin de transmis-
sie verwijderd, die er tijdens het vervoer van uw trekker kan
zijn ontstaan.
BELANGRIJK: MOCHT UW TRANSMISSIE VOOR ON-
DERHOUD OF VERWISSELING VERWIJDERD MOETEN
WORDEN, DAN DIENT HIJ NA DE INSTALLATIE ONTLUCHT
TE WORDEN, VOORDAT U DE TREKKER GEBRUIKT.
Parkeer de trekker veilig op een vlakke ondergrond zodat
hij in geen enkele richting kan wegrollen. Voor de volgende
handeling moet de parkeerrem uitgeschakeld zijn.
Schakel de transmissie uit door de freewheel-hendel in
de free wheel-stand te plaatsen.
Start de motor en breng de gashendel naar de stand Lang-
zaam. Controleer of de parkeerrem uitgeschakeld zijn.
Druk het vooruitrijpedaal volledig in. Houdt deze vijf (5)
seconden ingedrukt en laat dan los. Druk het achteruitri-
jpedaal volledig in. Houdt deze vijf (5) seconden ingedrukt
en laat dan los. Herhaal deze procedure drie (3) keer.
Stop de trekker door de contactsleutel naar de stand
“OFF” (UIT) te draaien.
Schakel de transmissie in door de freewheel-hendel in
de rijstand te plaatsen.
Start de motor en breng de gashendel naar de stand
Langzaam.
Rijd de trekker ongeveer 1 meter 50 vooruit en vervolgens
1 meter 50 achteruit. Herhaal dit drie keer.
Uw trekker is nu klaar voor normaal bedrijf.
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna CTH194 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna CTH194 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 10,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info