665357
5
Zoom out
Zoom in
Previous page
1/20
Next page
5
GB
To open door
Dryer Description
Control Panel
The On/Off button/ light , if the dryer is running and this
button is pressed and held for more than 3 seconds the dryer
is turned off. The light signals that your dryer is in use or ready
to select a programme.
The Programmes knob sets the programme: rotate until the
indicator is pointing to the programme you want to select (see
Start and Programmes).
The Option buttons/ lights select available options for your
selected programme. The lights indicate that the option has
been selected (see Start and Programmes).
The Display Panel has three sections: Sensor Dry = Drying
level, Timed dry = Drying time and Time to End / Delay start
each with a corresponding selection button (see The Display).
START/PAUSE button with indicator light : when the
green indicator light flashes slowly, press the button to
start the programme. When the cycle has started, the
indicator light is illuminated in a fixed manner. To pause the
programme, press the button again; the indicator light will
turn orange and begin to flash again.
To restart the programme from the point at which it
was interrupted, press the button again (see Start and
Programmes).
The Programme Progress Lights indicate each state of
the programme by turning on as appropriate (see Start and
Programmes).
Note: this light also flashes amber during post care phase.
The Empty Water indicator H2O signals that the water
container should be emptied. The light will take a few seconds
to go out after replacing the empty water container; the dryer
must be running for this to happen (see The Controls).
Note: if the water bottle is full the display shows H2O and
the indicator flashes, the heat is turned off and your clothes
will not dry.
The Empty Water / Clean Filter Light gives a reminder
before every programme, that its essential to clean the filter and
empty the water container every time the dryer is used (see
Maintenance and Care).
The Clean Condenser Light gives a reminder, that its
essential to clean the condenser at regular intervals (see
Maintenance and Care).
The Child Lock button/light Press and hold this button after
selecting your programme and any options. This prevents the
programme settings from being changed.
When the light is lit the other buttons and programme knob are
disabled. Hold the button to cancel and the light will go out.
ECO Light - this light is illuminated as you select options that
use less energy (see the controls).
The Features
Pull on handle
Condenser unit
(cover open)
Water
container
Rating
Plate
Condenser
cover handle
(Pull to open)
Filter
Air Intake
Grille
Model
& Serial
Numbers
Option Buttons and Lights
On/Off Button & Light
Display Panel
Child Lock
Button & Light
Start/Pause
Button & Light
Clean
Condenser
Light
Programme
Progress Light
Programme Knob
Empty
Water /
Clean Filter
Light
ECO
Light
Sensor Dry
Timed Dry
Delay
Timer
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hotpoint-Ariston AQC9 BF7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston AQC9 BF7 in the language / languages: English as an attachment in your email.

The manual is 1,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info