776259
4
Zoom out
Zoom in
Previous page
1/62
Next page
4GMC-I Messtechnik GmbH
Key
Overview of Device Settings and Measuring Functions
Battery display
Measuring function
Measurement in Memory occupancy
Measured
Parameter
Display Panel
PE
Save value
Battery full
Battery OK
Battery weak
Battery (almost) dead
Battery Display
BAT
BAT
BAT
BAT
Memory Occupancy Display
MEM Memory half full
MEM Memory full > transfer data to PC
Connection Test – Mains Connection Test ( section 16)
N
PE
LN
PE
L)(
Connection OK L and N reversed
N
PE
L N
PE
L
x
N
PE
L N
PE
L
xx
RUN READY
Connection test section 16
U < 8 V
L
PE
N
These operating instructions describe a tester
with software version SW-VERSION (SW1) 01.17.00.
progress / stopped
quantities
Switch
Setting
descrip-
tion as of
Picto-
graph
Device settings
Measuring Functions
SETUP
page 9
Brightness, contrast, time/date
Language (D, GB, P), profiles (ETC, PS3, PC.doc)
Default settings
< Test: LED, LCD, acoustic signal
Battery test
Measurements with Line Voltage
U
page 16
Single-phase measurement, UL-N-PE
UL-N Voltage between L and N
UL-PE Voltage between L and PE
UN-PE Voltage between N and PE
fFrequency
3-phase measurement U3~
UL3-L1 Voltage between L3 and L1
UL1-L2 Voltage between L1 and L2
UL2-L3 Voltage between L2 and L3
fFrequency
Phase sequence
Appears for all
measurements shown
below:
U / UNLine voltage / nominal line voltage
f / fNLine frequency / nominal line frequency
IΔN
page 18
UIΔN Touch voltage
ta Tripping time
RE Earth resistance
IF
page 20
UIΔN Touch voltage
IΔResidual current
RE Earth resistance
ZL-PE
page 25
ZL-PE Loop impedance
IK Short-circuit current
ZL-N
page 27
ZL-N Line impedance
IK Short-circuit current
RE
page 29
2-pole meas. (ground loop) RE(L-PE)
2-pole meas. / country-specific plug
Measurements at voltage-free objects
RLO
page 35
RLO Low-resistance with polarity reversal
RLO+, RLO–
Low-resistance, single-pole
ROFFSET Offset resistance
RINS
page 32
RINS Insulation resistance
RE(INS) Earth leakage resistance
U Voltage at the test probes
UINS Test voltage
Ramp: triggering/breakdown voltage
EXTRA
page 37
ΔU Voltage drop measurement
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gossen Metrawatt Profitest Intro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gossen Metrawatt Profitest Intro in the language / languages: English as an attachment in your email.

The manual is 1.69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info