624624
7
Zoom out
Zoom in
Previous page
1/8
Next page
1110
CABLE ROUTING
REAR BRAKE
A: Prior to routing the rear brake, you’ll want
to remove the Top Tube Cable Stop near the
seat tube.
B: Place the Top Tube Cable Stop and 2mm
bolt aside to be in stalled after routing the rear
brake cable. Route the Rear Brake Cable into
the Top Tube Cable Stop nearest to the frame’s
head tube as pictured.
Feed cable through the top
tube until cable exits rear top tube
grommet nearest to the seat tube.
C: Replace the top tube grommet
and tighten the 2mm screw to
secure in place as shown.
D: Slide the piece of Rear Brake
Cable housing (ferrule side) into
the top tube grommet as shown.
E: Route the Rear Brake Cable
into the rear brake tension bolt as
shown and attach cable to brake.
***If using hydraulic brakes, be sure
to replace the Cable Housing Stop
with a press-fit silicone Hydraulic
Brake Housing Stop before routing
Hydraulic Brake Housing
*** REFER TO THE BRAKE MANUFACTURERS’ INSTALLATION
INSTRUCTIONS BEYOND THESE STEPS.
CONTACT
INFORMATION
Felt Racing, LLC
12 Chrysler
Irvine, CA 92618
USA
WWW.FELTBICYCLES.COM
INFO@FELTBICYCLES.COM
Felt GmbH
Industriestr. 39
26188 Edewecht
Germany
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Felt Z series Disc Carbon at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Felt Z series Disc Carbon in the language / languages: English as an attachment in your email.

The manual is 2,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info