485595
45
Zoom out
Zoom in
Previous page
1/100
Next page
45
GB
Place the drained coffee grounds
container under the coffee outlet as
illustrated.
It serves as a collecting tank for the
cleaning water. Fig 26
Press button k “Start cleaning
programme” again. The indicator h
“Empty coffee grounds container”
stops flashing and switches to steady
light. The programme starts; the
process should not be interrupted.
Fig.21
The programme executes 5 cycles
with fresh water rinsing. The pause
periods enable the cleaning tablet to
take effect. The programme must be
restarted in case of power failure!
Indicator c flashes intermittently
during the cleaning operation.
The cleaning operation is interrupted
after about 5 minutes, if the indicator
h “Empty coffee grounds container”
flashes.
Empty the coffee grounds container
and insert it again. The appliance
switches on directly there after. The
resulting noises are normal. The
indicator h “Empty coffee grounds
container” goes off.
If indicator h “Empty coffee
grounds container” flashes again,
place the drained coffee grounds
container under the coffee outlet as
illustrated. It serves as a collecting
vessel for the cleaning water. Fig 26
Method phase 2: rinse
Press button k “Start cleaning
programme” again. The indicator h
“Empty coffee grounds container”
stops flashing and switches to steady
light. The programme is continued;
the process should not be interrup-
ted. Fig.21
The cleaning procedure is ended
after about 1 minute, if the indicator
h “Empty coffee grounds container”
flashes.
Empty the coffee grounds container
and insert it again so that indicator h
“Empty coffee grounds container”
goes off. The indicator k “Start
cleaning programme” goes off too.
Turn the coffee beans container into
the required position and fill up the
water reservoir.
The appliance is now ready for
operation again.
We recommend pouring away the
first cup of coffee made after running
the cleaning programme.
15.7 Running the Descaling Program
The descaling program allows you to
simply and effectively descale your
coffee machine. The coffee machine
should be regularly descaled, every 4-6
months, but no later than when the
"Descale" key (Fig. 3, j) indicator
flashes.
Important: Do not under any circum-
stances use descalers based on formic
acid or vinegar or pure lemon juice, as
these can damage the appliance. Pow-
dered descalers are not recommended.
Use only limescale removal products
recommended by FAGOR. You may
obtain them from our authorised dis-
tributor network or through our Cus-
tomer Care Helpline.
The descaling process runs over
two phases and should not be inter-
rupted.
Phase 1: descaling phase, and Phase 2:
flushing phase.
In the event of a power failure or
interruption, the program must be
restarted!
Phase 1: Descaling
Before starting the descaling program,
switch the coffee machine off.
Remove and clean the coffee-making
unit (refer to „Cleaning the Coffee-
making Unit"). The coffeemaking unit
is replaced not until after the des-
caling.
Replace the service cover.
Empty the coffee grounds container
and re-insert it.
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fagor CAT-40 NG at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fagor CAT-40 NG in the language / languages: English, French, Portuguese, Spanish as an attachment in your email.

The manual is 11,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info